29
ASSEMBLY
Assembly
Left- or right-hinged oven door
■ Remove the protective frame by removing
screws 1 and 2 (see figure 7). Remove the
frame and replace screws.
■ Remove the upper hinge by removing the
two screws. Lift the door from the lower
hinge (see figure 7a).
■ Re-fasten the hinge to the door.
■ Turn the door around so that the handle is
on the other side.
■ Remove the hinge that is now at the top
(see figure 7b). Attention: the ring belongs
in the lower hinge.
■ Slide the door into the lower hinge. Place
the ring between the hinge and the hinge
holder (see figure 7c).
■ Now reassemble the upper hinge.
■ Assemble the protective frame on the other
side of the oven.
■ Unscrew the catch pin of the door lock and
move it to the other side.
fig. 7a
fig. 7b
Installation
General
When the appliance does not have a
connecting cable and plug, then it may be
connected to the mains only by an approved
installer.
After installation the wall socket and plug
must be accessible at all times.
please note:
The power rating and required mains voltage
are shown on the rating plate at the back of
the oven. Connection should take place
according to national and local regulations.
Electrical connection
230 V -50 Hz.
Connecting cable + plug.
Wiring diagrams
■ There is a label showing the wiring
diagrams on the underside of the appliance.
Combination of oven with Pelgrim cooker
(see figure 5)
For installation of this combination appliance,
see the cooker instructions.
Solo oven (see figure 6)
■ Connect oven to the electrical mains.
■ Slide the oven into the cupboard.
■ Open the oven door and fasten the oven
with two screws on each side wall.
