Cleaning
Filters
■ Wash aluminium filters every week in
soapy water. The cleaning agents will
make the aluminium filter turn dull, this is
normal.
General
This appliance should be connected to the
power supply by a recognized fitter who is
familiar with, and works according to the
correct safety regulations. This appliance
meets the European requirements CEE 89/336
EMC and CEE 73/23; 93/68 LVD.
Important that you know
■ If the cooker hood is to be fitted to an
existing duct no other appliances, such as
a geyser or heater, may be connected to
that same duct.
■ Consider local regulations with respect to
the ventilation of gas appliances!
■ The cooker hood should be mounted at
least 650 mm above the hob.
■ The shorter the duct, and the fewer the
bends in it, the better the cooker hood will
work.
■ Before you start drilling check that there
are no installation cables present.
■ The diameter of the outlet flange is 125 mm,
a duct with the same diameter is best.
Mounting the canopy hood
■ First determine the position and distance
with regard to the mounting brackets. Mark
the holes that must be drilled and drill the
holes.
■ Fix brackets (A) to the wall with the plugs
and screws provided.
■ Screw the hood to the wall with the plugs
and screws (B) provided.
■ On the back of the canopy hood are 2 holes
with a diameter of 8mm for the 2 plugs/
screws (C) to fix the hood.
■ Connect the duct.
■ Fit the short cylinder to the mounting
bracket (A) and pull the long cylinder to the
top of the canopy hood.
■ Screw the chimney in place from the inside
of the canopy hood (remove filters).
INSTALLATION11
Removing the filter panel
Switch off the electricity! Remove the plug
from the socket or switch the electricity off at
the mains. Pull the grille towards you and tilt it
downwards at the front.
Replacing carbon filters
The carbon filter must be used if the cooker
hood is not connected to a duct (see
extraction systems on page 8).
Note:
■ The carbon filter must be replaced at least
twice a year, depending on how much the
cooker hood is used.
■ Carbon filters cannot be cleaned to use
again.
■ Saturated carbon is harmful to the
environment, replace the filter regularly.
Fitting the carbon filter
Place the carbon filter KF 90 (C) on the filter
panel in the way that is shown and fit the filter
panel in the hood.
Changing the light bulbs
PSK 675 / 975
Remove the filter panel.
Change the light bulb.
PSK 986/676/976
Remove the cover (1) by turning it counter
clockwise. Pull the bulb (2) in the direction of
the arrow and out of the holder, then fit the
new bulb. Take care not to touch the bulb with
your hands when you replace it, since direct
contact with the skin can result in the bulb
burning out.
Cleaning
Cooker hood
Clean the cooker hood with soapy water and a
soft cloth, then wipe with clean water to rinse.
Do not use aggressive cleaning agents such
as soda. The cooker hood paintwork will stay
looking nice if you wax it occasionally.
Stainless steel canopy hoods
Do not use any sort of scourer. Treat with
Stahlfix (supermarket) and polish with the
structure of the stainless steel.
10 MAINTENANCE
