Bedienungsanleitung PerfectPro RB2BT - Rockbox 2 (Seite 5 von 44) (Deutsch, Englisch, Holländisch, Französisch)

742406

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

POWER SUPPLY

AC operation

Before plugging the AC power cord into the AC socket, be sure the voltage is correct.

If you have batteries in the radio and using the AC power supply, the batteries will

automatically be disconnect.

AC power cord storage is designed to store the cord when the radio is not in use.

Note: In order to disconnect the unit from the mains completely, the AC plug should be

removed from the mains socket completely.

Battery operation

1. Toopenthebatterycompartment,rstturnthebatterycoverxturesanti-clockwise

to loosen and pull down the battery cover.

2. Insert 6 x C size (UM-2) battery with the correct polarity into the compartment. Close

 thebatterycoverandfastenthexturesbyturningclockwise.Closewelltoprevent

moist or dust from entering the compartment.

3. If the unit is not to be used for any extended period of time, it is recommended that

the batteries are removed from the radio.

The approximate power level of the batteries is displayed in the LCD display of the radio.

When the power level is very low the indication “Battery Low!” appears and the battery

symbolashesonthedisplay.Thebatteriesshouldthenbereplacedsoontocontinue

normal operation of the radio.

Notes:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type.

Donotexposethebatteriestoexcessiveheatsuchassunshine,reorthelike.

Batteries should not be disposed of by incineration and with household waste.

Disposable batteries should be taken to a suitable recycling centre if possible.

USING THE RADIO FOR THE FIRST TIME

1. Placetheradioonaatsurface.

2. Carefully extend the antenna located on the top of the radio. Adjust the antenna so

it is vertically extending above the radio.

3. Plugging the AC power cord into the AC socket. The radio will start up and the

display will show “WELCOME TO DIGITAL RADIO” for a few seconds. Then the

radio will automatically perform an auto scan of the Band III DAB channels and the

FM band, the display will show “ATS setting”.

4. When the scan is completed, the 10 strongest FM stations will be stored as presets.

The radio will switch to standby with the updated clock and date showing on the

display.

5. If no signals are found, the clock will not be updated. It may be necessary to

relocate the radio to a position giving better reception.

Additional metal telescopic antenna

You can use this as an alternative antenna for your radio in areas or locations where the

radio-signal (FM/DAB/DAB+) is weak to very weak.

ATTENTION; the standard antenna on the radio is exible, this antenna is not

exible.

Installing:Carefullyscrewoffthestandardexibleantenna.Firstcarefullyloosenthe

antenna with an open-end-wrench (size 14) – turn counter clockwise.

Carefully screw on the metal telescopic antenna and softly tighten it with an open-end-

wrench key (size 14) – turn clockwise

ATTENTION: do not use too much force when xing the antennas as this can

damage the screw threat of the antennas or make it break off.

5 6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

PerfectPro RB2BT - Rockbox 2 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info