You can choose to use the three options together or just one or two at a time. If you set the timer, the Repeller will
be activated every 30 minutes.
Set up
Button “sonic” (left): You can adjust the sonic range. By turning the knob clockwise, you increase the strength of
the sound and the range of protection.
The settings are as follows:
1. Deer
2. Foxes, raccoons and skunks
3. Dogs, squirrels, opossums and chipmunks
4. and 5. Cats, mice, rats and skunks
Button “frequency” (right): You can control and adjust the frequency. By turning the knob clockwise, the frequency
will be increased.
Button “frequency” positions are as below:
1. Off
2. 13.5KHZ – 19.5KHZ To repeal animals such as mice, rats, dogs, foxes and marters.
3. 19.5KHZ – 24.5KHZ To repeal animals such as cats, raccoons, badgers and skunks.
4. 24.5KHZ – 45.5KHZ To repeal animals such as bats, birds, pigeons and rodents
5. Alarm and strong flashing lights to repel animals such as raccoons, boars and martens.
6. All functions working: mode 1, mode 2, mode 3, and strong flashing lights.
Timer setting (smart mode)
If you turn on the smart mode, the Repeller will be activated every 30 minutes, independent of animals being
within the range of the PIR Sensor.
To Assemble and Install
1. Remove the cover of the battery compartment and install the 3.7 V 18650 2000 mAh lithium battery. Then close
the battery compartment (battery included).
2. Place the unit pointed towards the area you want to protect (for example, in a flowerbed or mounted from a
wall)
