782705

Pet-Mate Dog-Mate 215 Dog door Seite 2

2
Zoom out
Zoom in
Vorherige Seite
1/4
Nächste Seite
2
4
6
5
3
1
DOOR THICKNESS
+ 3/4” (19mm)
DOOR THICKNESS
+ 3/4” (19mm)
3/8” (10mm)
3/8” (10mm)
3/8”
(10mm)
3/8”
(10mm)
•Read all instructions before installing or using this product.
•Register your purchase on-line at www.pet-mate.com (see guarantee).
•Do not allow children to play with this product.
•This door is not designed to prevent the passage of children or small adults in either direction.
•Inspect product regularly for correct operation and damage. Do not use if in doubt.
•This product is designed for use with pets only, as described in these instructions.
•The locking system of this pet door is not intended as a security device.
•This pet door is not a fire resistant door and must not be used where there is a risk from
fire spread.
•The installer of this pet door is responsible for complying with all relevant building regulations.
•During installation of this pet door take appropriate care. Follow safety instructions for all tools
and wear appropriate personal protective equipment.
•Dispose of all packaging material properly.
NOTE: Plastic bags could cause suffocation - keep
away from children and animals.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Hereby, Pet Mate Ltd., declares that this product is in compliance with the essential requirements
and other relevant provisions of EU Directives. All Declarations of Conformity (DoC) may be viewed
at www.pet-mate.com/eudoc.
1. Remove locking panel from interior frame by simultaneously depressing the button marked 'PRESS'
and lifting up. Place frame in required position where it will not be exposed to prevailing winds with tape
as in Fig. 1. Note that the bottom of the aperture should be approximately level with your dogs stomach.
Mark position of mounting bolt holes and draw around the aperture with a sharp pencil. Remove frame
from door.
2. Drill bolt holes with a 1/4" (6mm) diameter drill taking care to keep the drill square (Fig. 2.) Note that for
installation in walls and doors more than 2" (50mm) thick we recommend that you attach the frames
using suitable screws (not supplied) and drill holes to suit.
3. Mark a cutting line 3/8" (10mm) outside the aperture drawn in Fig. 1 and drill a hole approximately 1/4"
(6mm) diameter within each corner as in Fig. 3. Cut out along the cutting line with an electric jigsaw or
similar tool taking care to cut square to the door.
4. Measure thickness of your door and using a sharp knife or scissors cut along the nearest guideline on
the four door liners to door thickness PLUS 3/4" (19mm). Do not trim off the notch(es) on the bottom
door liner (Fig. 4.) Also cut the mounting bolts supplied to your door thickness + 3/4" (19mm) using a
hacksaw as in Fig. 4 and file bolt ends for easy nut threading. For walls and doors greater than 2"
(50mm) thick we recommend that you cut your own door liner using suitable 3/32" (2mm) metal sheet
(not supplied).
5. Assemble 4 door liners into the slots provided in the exterior frame and tape temporarily in position as
shown in Fig. 5. Note that the 'notched' door liner is fitted to the bottom of the frame with the notch(es)
around the frame magnet(s). The door liners should be fitted with their smooth face innermost. Push
rubber seal supplied into groove in exterior frame as shown, leaving a drainage gap at bottom centre.
6. With the aid of a helper assemble dog door in position with tape ensuring that door liners locate properly
into interior frame, then fit nuts and bolts as shown in Fig. 6. Do not overtighten the fixing bolts. Check
flap swings freely. If it does not, check frames are undistorted and that interior frame is aligned with
exterior frame. Finally, cover fixings with the plastic caps supplied and remove temporary fixing tape.
7. For added security the 2 plastic pins should be inserted through the holes at the bottom of the interior
frame into the locking panel.
CLEANING
Clean using water only. Detergents and polishes may damage the plastic.
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Pet-Mate Dog-Mate 215 Dog door wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info