Bedienungsanleitung Petsafe PIF00-15001 (Seite 3 von 24) (Englisch)

770988

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

www.petsafe.net 3

These steps will help keep your pet secure and comfortable. Millions of pets are comfortable while they wear stainless

steel contacts. Some pets are sensitive to contact pressure. You may find after some time that your pet is very tolerant of

the collar. If so, you may relax some of these precautions. It is important to continue daily checks of the contact area. If

redness or sores are found, discontinue use until the skin has fully healed.

• You may need to trim the hair in the area of the Contact Points. Never shave your pet’s neck; this may lead to a

rash or infection.

• Always remove your pet’s Receiver Collar before performing any Transmitter testing.

• The Receiver Collar should not be on your pet when the system is tested. Your pet may receive an unintended correction.

• The Boundary Zone must be tested whenever an adjustment is made to the Transmitter setting to prevent unintended

corrections to your pet.

• If you use a collar and leash for training, be sure the extra collar does not put pressure on the Contact Points.

• To prevent an unintended correction, remove the Receiver Collar from your pet when indoors.

• Never remove power from the system when the collar is on the pet. This may activate the Receiver Collar.

• Radio Systems Corporation recommends the use of an Uninterruptible Power Supply (UPS) for use with your wireless

fence. Should the power go out at your home, your pet will be unprotected. Power outages can be unpredictable,

and the use of a UPS will provide you with some time to properly restrain your pet.

In rare instances, if your pet is near the boundary at the time when the power fails, it is possible that your pet will receive a

correction. This correction will stop after a 15 second timeout period has been reached. This is due to the operation of the

collar: the collar is activated by the absence of the containment signal.

While results will vary depending on the UPS manufacturer’s specifications the following are typical examples to guide

your choice of UPS:

• Using a 400 VA UPS a consumer should expect 3 hours of backup time.

• Using a 900 VA UPS a consumer could expect 8 hours of backup time.

If settings below maximum fence size are used, additional backup time will result. At minimum fence size settings backup

time may be more than two times the backup time estimated at maximum fence size.

• To prevent an unintended correction, after the Boundary Flags have been placed, be sure to set the Static Correction

on the Receiver Collar back to Level 1 Tone Only.

• Do not place anything on the top of the Transmitter or cover any ventilation holes. This may overheat the Transmitter

and cause early transmit failure.

• Do not place Transmitter in a closet or any other confined, unventilated area.

• Do not place Transmitter on a metal surface.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Petsafe PIF00-15001 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info