MULTIFUNCTION DISPLAYS
Access to the screen
This screen is opened and stored auto-
matically.
However, you can also open it, store it
and adjust it using the various manual
controls:
- opening or storing by means of
control A ,
- angle adjustments by means of
control B .
It is also fi tted with safety auto-reverse
protection.
Opening the screen
With the screen stored, press control A
to open it.
The screen opens automatically when
the ignition is switched on, when the
audio/telephone is switched on, when
an outgoing telephone call is made,
when a voice command is given and
when a warning message linked with
the STOP warning light is received.
Closing the screen
With the screen open, press control
A to store it.
The screen is stored automatically
when the ignition is switched off, after
approximately three seconds, if the
audio/telephone is off.
If you wish the screen to continue to
open or close automatically when
the audio/telephone is switched
on or off, the screen must not be
closed when the audio/telephone is
operating.
When the screen is open, you can ad-
just it precisely in different ways:
press the corresponding part of
control B to move the screen towards
you or towards the windscreen,
or
push or pull the screen gently by
hand.
Adjusting the position of the screen
Safety auto-reverse
If the screen meets an obstacle as it
opens or closes, the movement stops
immediately and is reversed by a
few millimetres.
After clearing the obstacle, issue the
command required again.
Storing the position of the screen
The system has four pre-set positions
in its memory.
Each time the screen is closed, the
system stores the last position of the
screen.
Each time the screen is re-opened, the
system returns the screen to the pre-set
position closest to that stored.
If you close the screen during
operation of the audio/telephone,
it will only re-open automatically
when an outgoing telephone call is
made, when a voice command is
given or when a warning message
linked with the STOP warning light
is received.
