9
Lighting and signalling
Lighting and signalling equipment in good working condition
is essential for safety.
Check the various lamps from time to time before starting
and when using your scooter to make sure that they are
working as they should.
- Lamp characteristics
Headlight/Diplight .................... S2 35/35W BA20d
Rear light and brake light ......... P2 21/5W BAY15d
Turn signal lights ............................. R10W BA15S
Speedometer lighting ........... W1,2W T5 (no base)
and arning lights .................. W1,2W T5 (no base)
Number plate light * ...............................W5W(T10)
Side lights * ...........................................W5W(T10)
All lamps are 12 volts
See your dealer or distributor immediately if one of the
lamps is not working properly.
- Changing bulbs
Front :
- Take the 4 screws out of the front panel
- Pivot the fittings over
- Change the bulb
To adjust the headlight : unclip the box at the bottom of
the left hand glove and adjust the screw to vary the
vertical angle.
At the back :
- Remove the two screws and the lens
- Change the bulb
Indicators :
- Remove the screw and the lens
- Change the bulb
* According to the model
C
D
D
A
D
C
A
B
B
