Bedienungsanleitung Philco PWD14S (Seite 20 von 21) (Englisch)

492066

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

Power Failure

If there is a power failure the wash cycle will be interrupted, and the wash programme

and functions will be suspended. When the power is restored, the wash programme

and functions will re-start from the same point and complete the programme.

During a power failure the water can be drained and the load can be removed from

the machine as follows:

Step 1. Switch off the machine both via the programme dial and the mains power

supply. Remove the plug from the mains power supply socket.

Step 2. Carefully move the machine so the rear of the machine is accessible. Please

follow the safety precautions that we recommend under the Warning and Safety

Instructions section of this manual.

Step 3. Unclip the drain hose from the rear panel of the machine and lower the hose

into a bowl on the ﬂoor. When the bowl is full raise the end of the drainpipe to a

height higher than the top of the appliance to stop the ﬂow of water. Empty and

replace the bowl and continue draining the machine until empty.

Step 4. Once the machine is fully drained of water, clip the hose to the rear of the

machine. Open the door and remove the load.

The door can be opened approximately 2 minutes after the power failure.

Do not force open the door.

Problem with the dispenser…

● Not all the detergent has been ﬂushed away.

1. Check the water supply tap is fully turned on.

2. Check the inlet hose is not kinked.

● The dispenser drawer will not close properly.

1. Check the drawer is aligned properly

2. Check the drawer is not clogged with detergent (see Care and

Maintenance)

● Steam is coming from the dispenser. The machine is designed to vent through the

drawer, this is nothing to worry about.

The clothes load is not dry…_

● Was sufﬁcient time or automatic setting selected to dry the clothes load? (Refer to

Drying Time Guide page 69.)

● Is the wash programme selected followed automatically by a drying programme?

(Refer to Programme Guide page 60.)

● Was the laundry correctly spun prior to drying? Select a spin programme to

remove the excess water.

● Has the correct drying programme been selected? Refer to the laundry care label

for guidance.

● The laundry may have been excessively wet at the end of the wash cycle eg. The

load was out of balance (see page 56). In this case the load may not have dried

within the maximum time allowed. Select a drying only programme (page 59) to

complete the drying.

Remember, you may be charged for the service call if incorrect installation or misuse

causes a problem with your machine.

Note: The use of environmentally friendly, phosphate-free detergents (check detergent

information on pack) can have the following effects:

● Waste water from rinsing may be cloudier because of the presence of a white

powder (zeolites) held in suspension, without the rinse performance being adversely

affected.

● Presence of white powder on laundry after washing, which is not absorbed by

the fabric and does not alter the colour of the fabric.

● The presence of foam in the ﬁnal rinsing water is not necessarily an indication of

poor rinsing. Carrying out more rinse cycles does not serve any purpose in such

cases.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philco PWD14S Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info