Bedienungsanleitung Philips 10FF2CWO (Seite 7 von 112) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

62606

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

Make sure all parts are correctly mounted before you switch on the appliance.

Only use the appliance when both clamps are locked.

Only unlock the clamps after you have switched off the appliance and the lter has stopped

rotating.

Do not operate the juicer for more than 40 seconds at a time when you juice heavy loads and

let it cool down sufciently afterwards. None of the recipes in this user manual constitute heavy

loads.

Do not remove the pulp container when the appliance is operating.

Always unplug the appliance after use.



This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Preparing for use

Wash all detachable parts (see chapter ‘Cleaning’).

2 Pull the mains cord out of the cord storage compartment at the back of the appliance (Fig. 2).

3 Place the juice collector in the appliance (1). To place the pulp container, tilt it forwards

slightly (2). Insert the top end of the pulp container rst and then push home the bottom

end (Fig. 3).

To empty the pulp container while you are juicing, switch off the appliance and carefully remove the

pulp container.

Note: Reassemble the empty pulp container before you continue juicing.

4 Put the lter in the juice collector (1). Hold the lid over the lter and lower it into position

(2) (Fig. 4).

Make sure the lter is tted securely onto the driving shaft (‘click’).

Always check the lter before use. If you detect any cracks or damage, do not use the appliance.

Contact the nearest Philips service centre or take the appliance to your dealer.

5 Snap the two clamps onto the lid to lock it into place (‘click’) (1). Align the groove in the

pusher with the small protrusion on the inside of the feeding tube and slide the pusher into

the feeding tube (2) (Fig. 5).

Make sure the clamps are locked into position on either side of the lid.

6 Put the lid on the juice jug to avoid splattering. Place the juice jug under the spout (Fig. 6).

7 Push the spout downwards before you start juicing.

Note: When the spout is in upward position, it functions as a drip stop when the appliance is switched off.

However, if you leave the spout in upward position during juicing, juice splashes out the spout.

Using the appliance

The appliance only functions if all parts are assembled properly and the lid is properly locked in

place with the clamps.

1 Wash the fruit and/or vegetables and cut them into pieces that t into the feeding

tube. (Fig. 7)

2 Make sure the juice jug is placed under the spout and the spout is in downward position.

3 Turn the control knob to setting 1 (low speed ) or 2 (normal speed) to switch on the

appliance. (Fig. 8)

ENGLISH 7

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips 10FF2CWO Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info