Bedienungsanleitung Philips 14PV375 (Seite 6 von 20) (Englisch)

33177

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Important for the United Kingdom

This apparatus is fitted with an approved 5 Amp

plug. To change a fuse in this type of plug pro-

ceed as follows:

1.Remove fuse cover and fuse.

2.Fix new fuse which should be a BS1362

5A,ASTA or BSI approved type.

3.Refit the fuse cover.

If the fitted plug is not suitable for your socket

outlets, it should be cut off and an appropriate

plug fitted in its place.

If the mains plug contains a fuse, this should

have a value of 5A. If a plug without a fuse is

used, the fuse at the distribution board should not

be greater than 5A.

How to connect a plug:

The wires in the mains lead are coloured in accor-

dance with the following code:

BLUE- 'NEUTRAL' ('N')

BROWN- 'LIVE' ('L')

4.The BLUE wire must be connected to the termi-

nal which is marked with the letter 'N' or

coloured BLACK.

5.The BROWN wire must be connected to the

terminal which is marked with the letter 'L' or

coloured RED.

6.Do not connect either wires to the earth termi-

nai in the plug which is marked with the letter

'E' or by the safety earth symbol or coloured

green or green-and-yellow.

Before replacing the plug cover, make certain that

the cord grip is clamped over the sheath of the

lead-not imply over the two wires.

Preparing the remote control for

operation

The remote control and

its batteries are packed

separately in the original

TV-Video Combi pack-

aging. You must install

the batteries in the remote control before use.

1.Take the remote control and the enclosed bat-

teries (2 batteries).

2.Open the remote control's battery compart-

ment and place the batteries in it as shown in

the picture and close the battery compart-

ment.

The remote control is now ready to use.

Its range is approximately 7 metres.

Connecting the cable

1.Insert the aerial cable plug into the

AERIAL at the back of the TV-Video Combi.

2.Connect the mains cable to the wall socket.

3.If the little red standby light (STANDBY ) at

the front panel of the set is not lit, please

switch on the set using the main power

switch. The power switch is located on the

left side panel of the set.

4.The following screen will appear on the TV.

You can find more details in chapter 'Preparation

for use'.

Connecting additional devices

You can connect additional devices such as

decoders, satellite receivers, camcorders, etc. to

the EXT1 socket.

1. Connecting the TV-Video Combi

PLEASE CONNECT AERIAL OR

CABLE TO THE TVCR

THEN...

PUSH P+

KEY

OR...

FOR PLAY ONLY PUSH PLAY

The respective scart socket is usually marked

on the decoder or satellite receiver.

[14 inch]

The severed plug must be destroyed to avoid a pos-

sible shock hazard should it be inserted into a 13A

socket elsewhere.

T6400EZ-UK(EN).qx3 03.2.20 3:09 PM Page 4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips 14PV375 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips 14PV375

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info