545818
29
Zoom out
Zoom in
Vorherige Seite
1/115
Nächste Seite
When you hover the pointer over a link . . .
1 - The pointer lights up.
2 - Press
OK
to open the link.
When you hover the pointer over a text field . . .
Press
OK
to enter text.
Pointer speed
You can adjust the speed of the pointer, the speed at which the
pointer moves on screen.
To adjust the speed . . .
1 - Press
and select
Setup
and press
OK
.
2 - Select
TV settings
and press
OK
.
3 - Select
General settings
>
Pointer and mouse speed
and
press
OK
.
4 - Press the arrows
(up) or
(down) to increase or lower
the speed.
5 - Press the arrow
(right) to test the speed you set.
6 - Press the arrow
(left) to return to the setting. You can
adjust the setting again.
7 - Press
OK
to store and close the setting.
8 - Press
, repeatedly if necessary, to close the menu.
Switch off
If you want to navigate the Smart TV and Internet pages with
the arrow keys only, you can switch off the pointer.
To switch off the pointer . . .
1 - Press
and select
Setup
and press
OK
.
2 - Select
TV settings
and press
OK
.
3 - Select
General settings
>
Remote control pointer
and
select
Off
.
4 - Press
, repeatedly if necessary, to close the menu.
6.6
IR sensor for RF remote control
The remote control of the TV uses RF (radio frequency) to send
its commands to the TV. With RF, you do not need to point the
remote control at the TV.
However, the TV can also receive commands from a remote
control that uses IR (infrared) to send commands. If you use
such a remote control, always make sure you point the remote
control at the infrared sensor on the front of the TV.
6.7
IR sensor for non-RF remote
control
The TV can receive commands from a remote control that uses
IR (infrared) to send commands. If you use such a remote
control, always make sure you point the remote control at the
infrared sensor on the front of the TV.
6.8
Pairing with TV
* Only for 7100, 7500 series TV
This remote control uses radio frequency (RF) to send its
commands to the TV. Contrary to remote controls using
infrared signals, with this remote control you can send
commands without pointing at the TV.
The TV will notify you when the battery power of the remote
control is low.
Pairing the remote control
For the remote control to communicate with the TV, both TV
and remote control should be paired with each other. Once
paired, you cannot use the remote control to control another
TV.
When you started the initial TV installation, the TV invited you
to press the
OK
key, and by doing so, the pairing was done.
When you switch off the TV, the pairing is stored. You can pair
up to 5 remote controls with this TV.
29
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Philips 48PFK6409 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Philips 48PFK6409

Philips 48PFK6409 Bedienungsanleitung - Deutsch - 125 seiten

Philips 48PFK6409 Kurzanleitung - Deutsch - 12 seiten

Philips 48PFK6409 Kurzanleitung - Holländisch - 12 seiten

Philips 48PFK6409 Bedienungsanleitung - Holländisch - 121 seiten

Philips 48PFK6409 Bedienungsanleitung - Französisch - 125 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info