Bedienungsanleitung Philips-Avent SCD499 (Seite 8 von 168) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

507146

Zoom out

Zoom in

Vorherige Seite

1/168

Nächste Seite

Make sure your hands and the unit are dry when you insert the batteries.

1 Turn the battery compartment lid to the left ( Á OPEN) with the palm of your hand. (Fig. 3)

2 Remove the lid.

3 Insert four 1.5V R6 AA batteries (Fig. 4).

Place two batteries on top of each other and make sure the + and – poles of the batteries

point in the right direction.

4 Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ª) with

the palm of your hand to close it. (Fig. 5)

Note:When the batteries are running low, the battery symbol appears on the display.

Parent unit

Battery operation

The parent unit runs on two rechargeable 1.2V AAA NiMh batteries that are supplied with the

appliance.

Make sure your hands and the unit are dry when you insert the batteries.

1 Slide the battery compartment lid downwards to remove it (Fig. 6).

2 Insert the two rechargeable batteries (Fig. 7).

Make sure the + and – poles of the batteries point in the right direction.

3 Slide the battery compartment lid back onto the back of the parent unit until it locks into

position (‘click’) (Fig. 8).

4 Put the adapter in a wall socket and place the parent unit in the charger (Fig. 9).

The POWER light on the charger lights up.

5 Leave the parent unit in the charger until the batteries are fully charged



parent unit and let it charge continuously for at least 10 hours.

Charging normally takes 8 hours, but it takes longer when the parent unit is switched on

while charging. To keep the charging time as short as possible, switch off the parent unit

during charging.

The POWER light on the charger stays on, even when the batteries are fully charged.

When the batteries are fully charged, the parent unit can be used cordlessly for at least 24

hours.

Note: The operating time of 24 hours is based on the assumption that the baby unit transmits 25% of

the time and is in standby mode for the rest of the time (when the baby does not make any sound).

Note: When the parent unit batteries are charged for the rst time, the operating time is less than 24

hours. The batteries only reach their full capacity after you have charged and discharged them four times.

Note: When the battery symbol on the display is empty and the parent unit beeps, the batteries are

running low. Place the parent unit in the charger.

Note: When the parent unit is not in the charger, the batteries gradually discharge, even when the parent

unit is switched off.

Mains operation

1 Make sure you have inserted the rechargeable batteries in the parent unit.

2 Put the adapter of the charger in the wall socket and place the parent unit in the

charger (Fig. 9).

ENGLISH8

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips-Avent SCD499 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info