1055
98
Zoom out
Zoom in
Vorherige Seite
1/120
Nächste Seite
88
Programming recordings with the GUIDE
Plus+
®
System
The GUIDE Plus+
®
System has made it even easier to programme recordings. All you have to do
is select the show you want to record from a channel listing.
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Press GUIDE/TV on the remote control.
3 Use P+ A or P- B to select the TV station, and D or C to select
the show to record.
a I do not see all available TV channels
b Please check your correct channel line up in the 'Editor' screen.
Read therefore the section 'The 'Editor' screen in the chapter 'The GUIDE
Plus+
®
system.
b The GUIDE Plus+
®
'Grid' screen contains only those TV channels that
were detected by the GUIDE Plus+
®
system using a 'channel identification'.
TV channels that do not have this 'channel identification' are not available in
the GUIDE Plus+
®
system.
Please use 'Manual TIMER programming' to program TV shows of such TV
channels.
Problem
4 Confirm using the red function button of the remote control
('Record' on the screen).
You can also use REC/OTR n on the remote control or
RECORD on the DVD recorder.
The TV show is programmed for recording.
Read the information on the screen.
a 'Warning, this programme number has not been allocated, please
go to Editor to set it.' appears on the screen
b The programme number of the TV channel is not available in the GUIDE
Plus+
®
system or allocation is wrong.
To change or check the channel data, proceed as follows:
1 Press P+ A .
2 Select 'Editor' with C .
3 Select the TV channel using P- B or P+ A .
4 Press C to go to the right tile.
In case you can receive the selected channel only via an external
receiver, press the red button to select the corresponding source.
5 Press the green button.
6 Enter the programme number of the TV channel using the number
buttons.
If the source you have selected is an external receiver, enter the
programme number that you would also enter at the external receiver
for this TV channel.
Problem
Programming a recording (TIMER)
98

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Philips DVDR80 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Philips DVDR80

Philips DVDR80 Bedienungsanleitung - Deutsch - 124 seiten

Philips DVDR80 Bedienungsanleitung - Holländisch - 126 seiten

Philips DVDR80 Bedienungsanleitung - Spanisch - 126 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info