Bedienungsanleitung Philips EP0824 (Seite 13 von 202) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

811370

Zoom out

Zoom in

Vorherige Seite

1/202

Nächste Seite

English

3Disassemble the two parts (Fig. 31) and rinse them with fresh water or clean them in the dishwasher.

Make sure that the small hole on the metal tube (Fig. 32) is completely clean and not clogged by milk

residues.

4Reassemble the two milk frother parts and reattach the milk frother to the machine.

AquaClean water filter

Your machine is AquaClean enabled. You can place the AquaClean water filter in the water tank to preserve

the taste of your coffee. It also diminishes the need for descaling by reducing limescale build-up in your

machine. You can purchase an AquaClean water filter from your local retailer, from authorized service

centers or online at www.philips.com/parts-and-accessories.

AquaClean icon and light

Your machine is equipped with an AquaClean water filter light (Fig. 33) to indicate the status of the filter.

Use the table below to see what actions are required when the light is on or when it is flashing.

When you use the machine for the first time, the AquaClean light starts flashing

orange. This indicates that you can start using the AquaClean water filter. If you do not

activate an AquaClean water filter, the light will switch off automatically after a while.

Once you have installed the filter and activated it with the AquaClean icon, the

AquaClean light turns blue to confirm that the AquaClean water filter is active.

When the filter is exhausted, the AquaClean light starts flashing orange again to

remind you to replace the filter with a new one.

When the orange AquaClean light is off, you can still activate an AquaClean filter, you

will need to descale the machine first.

Activating the AquaClean water filter (5 min.)

The machine does not automatically detect that a filter has been placed in the water tank. Therefore you

need to activate each new AquaClean water filter that you install with the AquaClean icon.

When the orange AquaClean light is off, you can still activate an AquaClean water filter, but you will need

to descale the machine first.

Your machine has to be completely limescale-free before you start to use the AquaClean water filter.

Before activating the AquaClean water filter, it has to be prepared by soaking it in water as described below.

If you don't do this, air might be drawn into the machine instead of water, which makes a lot of noise and

prevents the machine from being able to brew coffee.

1Make sure that the machine is switched on.

2Shake the filter for about 5 seconds (Fig. 34).

3Immerse the filter upside down in a jug with cold water and shake/press it (Fig. 35).

4The filter is now prepared for use and can be inserted into the water tank.

5Insert the filter vertically onto the filter connection in the water tank. Press it down to the lowest possible

point (Fig. 36).

6Fill the water tank with fresh water and place it back into the machine.

7Place a bowl under the hot water spout/milk frother.

8Press the AquaClean icon for 3 seconds (Fig. 37). The start light starts to pulse.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips EP0824 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info