Bedienungsanleitung Philips EP2333 (Seite 16 von 618) (Alle Sprachen)

811344

Zoom out

Zoom in

Vorherige Seite

1/618

Nächste Seite

English

Activating the AquaClean water filter (5 min.)

The machine does not automatically detect that a filter has been placed in the water tank. Therefore you

need to activate each new AquaClean water filter that you install with the AquaClean icon.

When the orange AquaClean light is off, you can still activate an AquaClean water filter, but you will need

to descale the machine first.

Your machine has to be completely limescale-free before you start to use the AquaClean water filter.

Before activating the AquaClean water filter, it has to be prepared by soaking it in water as described below.

If you don't do this, air might be drawn into the machine instead of water, which makes a lot of noise and

prevents the machine from being able to brew coffee.

1Make sure that the machine is switched on.

2Shake the filter for about 5 seconds (Fig. 42).

3Immerse the filter upside down in a jug with cold water and shake/press it (Fig. 43).

4The filter is now prepared for use and can be inserted into the water tank.

5Insert the filter vertically onto the filter connection in the water tank. Press it down to the lowest possible

point (Fig. 44).

6Fill the water tank with fresh water and place it back into the machine.

7If attached, remove the LatteGo.

8Place a bowl under the hot water spout/milk frother.

9Press the AquaClean icon for 3 seconds (Fig. 45). The start light starts to pulse.

10 Press the start/stop button to start the activation process.

11 Hot water will be dispensed from the hot water spout/milk frother (3 min.).

12 When the activation process is finished, the blue AquaClean light goes on to confirm that the AquaClean

water filter has been activated correctly.

Replacing the AquaClean water filter (5 min.)

After 95 liters of water have flowed through the filter, the filter will cease to work. The AquaClean light

turns orange and starts to flash to remind you to replace the filter. As long as it flashes, you can replace the

filter without having to descale the machine first. If you do not replace the AquaClean water filter, the

orange light will go out eventually. In that case you can still replace the filter but you first need to descale

the machine.

When the orange AquaClean light flashes:

1Take out the old AquaClean water filter.

2Install a new filter and activate it as described in chapter 'Activating the AquaClean water filter (5 min.)'.

Replace the AquaClean water filter at least every 3 months, even if the machine does not yet indicate that

replacement is required.

Deactivating the AquaClean reminder

If you do not want to use Philips AquaClean water filters anymore, you can always deactivate the AquaClean

reminders (AquaClean light flashing orange):

1Press the on/off button to switch off the machine.

2When the machine is switched off, press and hold the AquaClean icon until the light in this icon goes on.

The start light starts flashing.

3Tap the AquaClean icon again to deactivate the reminders. The light in the AquaClean icon goes off.

4Press the start/stop button to confirm your choice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips EP2333 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info