Bedienungsanleitung Philips EP3558 (Seite 20 von 28) (Englisch)

666107

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

CALC

CLEAN

CALC

CLEAN

4 Pour the descaling solution into the water tank. Fill the water tank with

fresh water up to the CALC CLEAN level indication. Place the water tank

back into the machine. Press the OK button to confirm.

The first phase of the descaling procedure starts. The machine starts

dispensing the descaling solution at intervals.

The display shows the descaling icon, the phase indication and the

duration. This first phase takes 20 minutes.

5 Let the machine dispense the descaling solution until the water tank is

empty.

6 Remove the water tank and rinse it.

7 Fill the water tank with fresh water up to the CALC CLEAN level

indication. Place the water tank back into the machine.

8 Remove and rinse the milk carafe. Fill the milk carafe with water up to the

MIN level indication. Insert the milk carafe into the machine and open the

milk froth dispensing spout.

9 Remove and empty the container and place it back under the coffee

dispensing spout. Press OK to confirm.

10 The second phase of the descaling procedure starts, which is the rinsing

cycle. This phase takes 3 minutes. The display shows the rinsing icon and

the duration of the phase.

Note: If the water tank is not filled up to the CALC CLEAN level, the

machine may require another rinsing cycle.

11 Wait until the machine stops dispensing water. The descaling procedure

is finished when the tick appears on the display.

12 Press the OK button to exit the descaling cycle. The machine starts

heating up and performs the automatic rinsing cycle.

13 Remove and empty the container.

14 Perform the 'Weekly cleaning of the milk carafe' procedure to clean the

milk carafe after descaling.

15 Clean the brew group by performing the 'Weekly brew group cleaning'

cycle.

16 Install a new AquaClean filter in the water tank.

Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

If the machine gets stuck during descaling, you can exit the descaling

procedure by pressing the standby button. If this occurs, or in case of a

power failure or accidental disconnection of the cord, do the following:

1 Empty and rinse the water tank thoroughly.

2 Fill the water tank with fresh water up to the CALC CLEAN level indication

and switch the machine back on. The machine will heat up and perform

an automatic rinsing cycle.

3 Before brewing any beverages, perform a manual rinsing cycle. To

peform a manual rinsing cycle, first dispense half a water tank of hot

water and then brew 2 cups of pre-ground coffee without adding ground

coffee (see 'Brewing coffee with pre-ground coffee').

Note: If the descaling procedure was not completed, the machine will

require another descaling procedure as soon as possible.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips EP3558 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips EP3558

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info