Bedienungsanleitung Philips EP5445 (Seite 17 von 242) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

737474

Zoom out

Zoom in

Vorherige Seite

1/242

Nächste Seite

When the machine needs descaling, a message appears on the display.

1 Touch the clean icon on the user interface and select 'Descaling' in the menu.

2 Follow the instructions on the screen.

3 If attached, remove LatteGo or the milk frother.

4 Remove the drip tray and the coffee grounds container, empty them and put them back into place.

5 Remove the water tank and empty it. Then remove the AquaClean water filter.

6 Pour the whole bottle of Philips descaler in the water tank and then fill it with water up to the Calc

/ Clean indication (Fig. 48). Then place it back into the machine.

7 Place a large container (1.5 l) under the coffee dispensing spout and the water spout.

8 Press the start/stop button to start the descaling procedure. The descaling procedure lasts

approximately 30 minutes and consists of a descaling cycle and a rinsing cycle.

9 Wait until the machine stops dispensing water. Refill the water tank when the message appears on

the display. The descaling procedure is finished when the machine stops dispensing water.

10 Install and activate a new AquaClean water filter in the water tank.

When the descaling procedure is finished, the machine reminds you to install the new

AquaClean filter (see 'Replacing the AquaClean water filter (5 min.)').

Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

You can exit the descaling procedure by pressing the on/off button on the control panel. If the

descaling procedure is interrupted before it is completely finished, do the following:

1 Empty and rinse the water tank thoroughly.

2 Fill the water tank with fresh water up to the Calc / Clean level indication and switch the machine

back on. The machine will heat up and perform an automatic rinsing cycle.

3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first

dispense half a water tank of hot water by repeatedly selecting the hot water function and then

brew 2 cups of pre-ground coffee without adding ground coffee.

If the descaling procedure was not completed, the machine will require another descaling

procedure as soon as possible.

Ordering accessories

To clean and descale the machine, only use the Philips maintenance products. These products can be

purchased from your local retailer, from the authorized service centers or online at

www.philips.com/parts-and-accessories. To find a full list of spare parts online, enter the model

number of your machine. You can find the model number on the inside of the service door.

Maintenance products and type numbers:

Descaling solution CA6700

AquaClean water filter CA6903

Brew group grease HD5061

Coffee oil remover tablets CA6704

Brita-filters are not compatible with this machine.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips EP5445 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info