Solution
Check the cord, the plug and the wall
socket.
Set the iron to the appropriate
temperature (see Setting the
temperature).
Fill the water tank (see Filling the
water tank).
Set to steam position between 1-4
(see Steam ironing).
Set the temperature control to the
steam area (2 to MAX). Put the
iron on its heel and wait until the
amber pilot light has gone out before
you start ironing.
Put the iron in horizontal position and
wait for a while before using the
(Vertical) Shot of Steam function
again.
Set the temperature control to the
steam area (2 to MAX). Put the
iron on its heel and wait until the
amber pilot light has gone out before
you start ironing.
Press to close the filling cap tightly
until you hear a click.
Set the iron to the appropriate
temperature (see Steam ironing).Types
GC3117, GC3116, GC3114, GC3113,
GC3112, GC3111, GC3110, GC3106
do not use steam when using
temperature lower than 2 dots (2).
Empty the water tank before you
store the iron. Set the steam control
to position O and store the iron
upright on its heel.
Apply Calc-Clean a few times (see
Calc-Clean).
Shake the iron slightly to deactivate
the Auto-shut-off, the lamp will stop
blinking.
Possible cause(s)
Connection problem.
Temperature control set at MIN.
Not enough water in the water tank.
The steam control has been set to
position O.
The iron is not hot enough and/or
Drip Stop is activated.
The (Vertical) Shot of Steam function
has been used too often within a very
short period.
The iron is not hot enough.
The filling cap is not closed properly.
The iron is not hot enough.
The iron is put in horizontal position
with water still left in the water tank.
Hard water forms flakes inside the
soleplate.
Auto-shut-off is activated.
See "Auto-shut-off" section.
Problem
The iron is plugged in but the soleplate
is cold.
No steam
No Shot of Steam or No Vertical Shot
of Steam (GC3135, GC3130, GC3128,
GC3126, GC3125, GC3120, GC3117,
GC3116, GC3115, GC3114, GC3113,
GC3112, GC3111, GC3110 only)
Water droplets on fabric
Water drips from the soleplate after
the iron has been stored or cooled
down.
Flakes and impurities coming out from
soleplate during ironing.
Red pilot light blinks
(type GC3135 only).
ENGLISH10
