Possible cause
The plug has not been (properly) inserted into the wall socket.
There is a power failure. Check if the power supply works by
connecting another appliance.
The lamps are still too hot to go on. Let them cool down for 3 minutes
first.
The appliance was not sufficiently cooled and the overheating
protection switched the appliance off automatically. Remove the cause
of overheating (e.g. remove a towel that is blocking one or more vents).
Wait for 10 minutes and switch the appliance back on.
Check the fuse of the circuit to which the tanning appliance is
connected.The correct fuse type is a 16A standard fuse or an
automatic fuse.The fuse may also blow because you have connected
too many appliances to the same circuit.
You are using an extension cord that is too long and/or does not have
the correct rating (16A). Consult your dealer. Our general advice is not
to use an extension cord.
You are not following the tanning schedule suitable for your skin type.
The distance between the lamps and the surface you lie on is larger
than prescribed.
When the lamps have been used for a long time, the tanning capacity
will decrease.This effect only becomes noticeable after several years.
You can solve this problem by selecting a slightly longer tanning time or
by having the lamps replaced. After 750 operating hours an L will
appear on the display telling you that it is advisable to have the lamps
replaced.
You have not pushed the upper part of the appliance backward far
enough. Make sure you first push the upper part backward before
pushing it down (see 'Storage').
The appliance fails to unlock automatically. In that case you first have to
press unlocking button (B), after which you can fold the appliance back
into its transport position in the manner indicated in the chapter
'Storage'. If the appliance fails to unlock several times, contact your
dealer or a Philips service centre.
Problem
The appliance does not start
The fuse cuts off the power when
you switch on the tanning appliance
or during use.
Poor tanning results
The appliance cannot be put back
into transport position.
Troubleshooting
If the appliance does not work properly, this may be due to a defect. In that case we advise
you to contact your dealer or a Philips service centre.
The appliance may also fail to work properly because it has not been installed or is not used
in accordance with the instructions. In that case you are able to solve the problem yourself by
following the troubleshooting tips below.
ENGLISH
12
