8
Cleaning
1 Always unplug the appliance and let it cool down before you start cleaning it.
2 Clean the outside of the appliance with a damp cloth.
Do not let any water run into the appliance.
3 Do not use scouring pads.
Never use abrasive liquids like scouring agents, petrol or acetone to clean the appliance.
◗ You can clean the outside of the UV filters with a soft cloth sprinkled with some methylated spirits.
Storage
1 Let the appliance cool down for 15 minutes before you put it in transport position and store it.
◗ In the meantime, you can wind up the cord and put it in the base of the appliance together with the remote control.
2 Make sure the cord and remote control are stored properly,as they might otherwise get stuck between parts of the appliance when
you put the appliance in transport position (fig. 29).
3 Turn the centre lamp unit 90c to put it in a line with the side lamp units (fig. 30).
4 Firmly hold the upper part of the stand with one hand and loosen the height adjustment knob (A) by turning it anticlockwise (fig. 31).
5 Slide in the stand (fig. 32).
6 Firmly fasten the height adjustment knob (A) by turning it clockwise (fig. 33).
7 Turn the two side lamp units towards each other (fig. 34).
8 Grab the handle with both hands, put one foot against the appliance to prevent it from sliding away and tilt the upper part with the
stand backward (fig. 35).
The automatic unlocking system will only work if you tilt the upper part with the stand backward far enough. However, you should be
careful not to tilt it backward too far because you might lose your balance if you do.
9 Push the upper part down (fig. 36).
10 Lower it slowly onto the base (fig. 37).
11 Fasten the lamp units to the base by pushing both lock slides in the direction of the arrow (fig. 38).
Replacement
The light emitted by the tanning lamps will become less bright in time (i.e. after a few years in case of normal use).When this happens, you will
notice a decrease in the tanning capacity of the appliance.You can solve this problem by setting a slightly longer tanning time or by having the
tanning lamps replaced.
◗ The remote control of the appliance includes a counter that registers the number of operating hours.
1 Choose function •. Set the time to 00 and hold down the pause/repeat § button to display the number of operating hours (fig. 39).
The maximum number of hours the counter can display is 999.After it has reached this number, it will continue to count up from 000.
2 When you release the pause/repeat button, the number of operating hours disappears from the display.
◗ After 750 burning hours, an L will appear on the left-hand side of the display.This means that the tanning power of the appliance has
decreased so much that replacement of the tanning lamps is advisable (fig. 40).
Of course, you can choose to postpone replacement for a while by setting a longer tanning time.
3 To remove the L from the display,press the pause/repeat § button, with time indication 00 and function symbol• on the display. Hold
down the pause/repeat button and press first the ¢ button and then the £ button and the L will disappear from the display (fig. 41).
For type HB977 only: Have the infrared lamps replaced when they stop functioning.
The UV filters protect against undesired exposure. It is therefore important to have a damaged or broken filter replaced right away.
Have the tanning lamps (Philips HPA flexpower 400-600), infrared lamps (IRK 15020R or 4222 062 95600) and UV filters replaced by an
authorised Philips service centre. Only they have the knowledge and skills required for this job and the original spare parts for the
appliance.
Environment
The lamps of the appliance contain substances that can be harmful to the environment.When you discard the lamps, make sure they are not
thrown away with the normal household waste but are handed in at an official collection point.
◗ Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the environment (fig. 42).
Guarantee & service
If you need service or information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips Customer
Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your
country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.
ENGLISH
