Possible cause
Mains plug is not in wall socket.
No mains power (please check with other appliance).
Timer has not been set.
The lamp of the face tanner (HB556 only) is still too warm to restart (allow the lamp to cool down for
approx. 3 minutes).
Check the fuse of the circuit to which the tanning appliance is connected.The correct fuse type is a 16A
standard fuse or an automatic fuse.The fuse may also blow, because you have connected too many
appliances to the same circuit.
You are using an extension cord that is too long or does not have the correct current rating. Consult
your dealer. Our general advice is not to use an extension cord.
You followed a course which is not the most appropriate for your skin type.
The operational distance is larger than indicated.
When the lamps have been used for a long time, the UV light will decrease.This effect only becomes
noticeable after several years.You can solve this problem by selecting a longer tanning time or by having
the lamps replaced.
Problem
Tanning appliance does not switch on.
The power fuse switches the mains power off when
switching on or while using the tanning appliance.
Poor tanning results
Guarantee restrictions
The following parts are not covered by the terms of the international guarantee.
- tanning lamps
- acrylic sheet
Troubleshooting
If the tanning appliance should not operate as required, this may be due to a defect. In this case do not hesitate to apply to your dealer or to a
Philips Service Centre.
However, it is also possible that the appliance has not been installed according to the instructions or is used incorrectly.
If this is the case, you will be able to solve the problem immediately.
ENGLISH10
