Bedienungsanleitung Philips HD6596 (Seite 13 von 60) (Deutsch, Englisch, Holländisch, Französisch)

672116

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

If the descaling procedure is not performed correctly, scale residue remains behind in the machine.

This causes scale to build up more quickly and may cause permanent and irreparable damage to the

machine.

Use the correct descaler

Only citric acid-based descalers are suitable for descaling the machine. This type of descaler descales

the machine without damaging it. For the correct amount, see under ‘Descaling procedure’ below.

Each descaling mixture can be used only once. Use a new descaling mixture each time. We advise you

to use the special SENSEO® Descaler (HD7012/HD7011). Read the instruction leaflet in the package.

For more information on why it is important to descale, how to descale or which descaler to use, visit

our website at www.philips.com/descale-senseo.

Warning: Never use a descaler based on mineral acids such as sulphuric acid,

hydrochloric acid, sulphamic acid and acetic acid (e.g. vinegar). These descalers may

damage your coffee machine.

Descaling procedure

The descaling procedure consists of two descaling cycles and two flushing cycles. Do not interrupt the

descaling cycles and do not switch off the machine before you have performed the two flushing

cycles.

1 Fill the water reservoir with clean cold water up to the MAX indication and pour the water into a

bowl (Fig. 44).

2 Mix 50 grams of citric acid with the water in the bowl. Stir until the powder has dissolved (Fig. 45).

3 Fill the water reservoir with the descaling mixture and place it back on the machine (Fig. 47).

4 Remove the drip tray. Put a bowl with a capacity of at least 1.5 liters under the spout to collect the

descaling mixture (Fig. 8).

5 Place the 1-cup pod holder with a used coffee pod in it in the coffee machine. Close the lid and

make sure it is properly locked.

Note: Always put a used coffee pod in the pod holder when you descale the machine. This pod

serves as a ‘filter’ to prevent the sieve or hole in the pod holder from getting clogged with scale

residue.

Warning: Make sure that the lid is closed properly and the lid lever is locked before

you start descaling the machine.

6 Press the 1-cup button and the 2-cup button simultaneously.

7 During the descaling cycle, the water comes out of the machine at intervals. The CALC light, jug

button, 2-cup button and 1-cup button flash slowly in sequence (Fig. 46).

8 When the water reservoir is empty, the 1-cup button and CALC light start to flash quickly alternately

(Fig. 31).

9 Empty the bowl and place it back. Remove the used pod and the 1-cup pod holder. Place the

2-cup pod holder with one used pod in the machine. Close the lid.

10 Fill the water reservoir with clean cold water up to the MAX indication and pour the water into a

bowl (Fig. 44).

11 Mix 50 grams of citric acid with the water in the bowl. Stir until the powder has dissolved (Fig. 45).

12 Fill the water reservoir with the descaling mixture and place it back on the machine (Fig. 47). Then

press the 1-cup button to start the second descaling cycle.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips HD6596 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info