• Moreover you can fix a curl by pressing the cool
knob. The air stream will become cool so that
the curl is “secured”.
When the cool knob is released again, the air
stream will turn to the preset temperature.
Modelling
• Before modelling the hair it is advisable to dry
the hair a little with a towel first. Then apply a
styling mousse.
• To add volume close to the scalp you can use
the diffuser. The diffuser is also suitable for
drying longer hair.
With the long pins of the diffuser you can already
comb the hair in the required direction while still
drying to facilitate later modelling.
• If you use curlers or a styling brush, you can
mount the concentrator nozzle to dry with a very
effectively aimed air stream.
• When the curl is almost dry, you can fix it by
blowing cool air onto and through the curl,
holding the cool knob pressed in, or adjust the
air temperature switch to “Cool” position. The
curl will then keep its shape longer.
• If your hair is long and sleek, it will look fuller and
become more shiny if you brush it while drying.
You can also dry and brush it in turn.
5
Important
• Before connecting the appliance, check that the voltage indicated on the type
plate corresponds to the local mains voltage.
• Do not use this product near water in e.g. baths, washbasins, sinks.
If the product falls into water, unplug it immediately and dispose of it. It must not be used
again.
• Always ensure that the attachments are completely dry (on the inside as well as the outside!)
before affixing them to the styler.
• Always switch the appliance off before putting it down, even if it is only for a moment.
• For additional protection, the installation of a residual current device (RCD) with a rated
residual operating current not exceeding 30 mA is advisable in the electric circuit supplying
the bathroom. Ask your electrician for advice.
• Even when the appliance is switched off, the electricity has not been cut off. Always pull out
the mains plug when the appliance is not being used.
• Never obstruct the air inlet grille.
• This product is equipped with an automatic overheating protection device. If the appliance
overheats, it will switch off. Unplug the appliance. After cooling down for a few minutes, the
appliance can be used again. Before switching back on again, check the air inlet grille for
possible blockage by fluff, hair, etc. If in doubt, consult your dealer or an Authorised Philips
Service Centre.
• Check the condition of the mains cord regularly. Do not wind the mains cord around the
appliance.
• The mains cord of this appliance cannot be replaced. If the cord is damaged, the appliance
should be discarded.
• For examination or repairs always return the appliance to an Authorised Philips Service
Centre. Unqualified repair work can be dangerous for the user.
