513034
34
Zoom out
Zoom in
Vorherige Seite
1/42
Nächste Seite
34EN
8 Troubleshooting
Warning
Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at www.
philips.com/support.
Main unit
The buttons on the home theater do not
work.
Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
Picture
No picture.
Make sure that the TV is switched to the
correct source for the home theater.
No picture on a TV connected through HDMI.
Make sure that you use a High Speed
HDMI cable to connect the home theater
and TV. Some Standard HDMI cables do
not display properly for some images, 3D
video, or Deep Color.
Make sure that the HDMI cable is not
faulty. If it is faulty, replace it with a new
cable.
Press (Home) and then 731 on the
remote control to restore the default
picture resolution.
Change the HDMI video setting, or wait
for 10 seconds for auto recovery.
Discdoesnotplayhigh-denitionvideo.
Make sure that the disc contains high-
denition video.
Make sure that the TV supports high-
denition video.
Use an HDMI cable to connect to the TV.
Sound
No sound from home theater speakers.
Connect the audio cable from your home
theater to your TV or other devices.
You do not need a separate audio
connection when the home theater and
TV are connected through an HDMI ARC
connection.
Set up the audio for the connected device
(see 'Set up the audio' on page 12).
Reset your home theater to its factory
settings (see 'Apply factory settings' on
page 28), then switch it off and switch on
again.
On your home theater, press SOURCE
repeatedly to select the correct audio
input.
Distorted sound or echo.
If you play audio from the TV through the
home theater, make sure that the TV is
muted.
Audio and video are not synchronized.
1) Press SOUND SETTINGS. 2) Press
the Navigation buttons (left/right) to
select AUD SYNC, and then press OK. 3)
Press the Navigation buttons (up/down)
to synchronize the audio with the video.
Play
Cannot play a disc.
Clean the disc.
Make sure that the home theater supports
the type of disc (see 'Media formats' on
page 31).
34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

philips-htb3260

Suche zurücksetzen

  • Mein HTB3260 bringt nach Start eines Musikstückes am Bildschirm die Meldung "Videomodus kann nicht angezeigt werden" obwohl man vorher den Bildschirm mit der Auswahl der Quelle und Anwahl eines Musikstücks auf USB angezeigt wurde.... Eingereicht am 19-11-2017 12:28

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Philips HTB3260 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Philips HTB3260

Philips HTB3260 Bedienungsanleitung - Deutsch - 51 seiten

Philips HTB3260 Bedienungsanleitung - Holländisch - 47 seiten

Philips HTB3260 Bedienungsanleitung - Französisch - 50 seiten

Philips HTB3260 Bedienungsanleitung - Spanisch - 46 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info