Bedienungsanleitung Philips lc1041 (Seite 10 von 30) (Englisch, Holländisch)

330

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

POSITIONING THE PROJECTOR AND SCREEN

Position the projector perpendicular to the screen with all

feet flat and level to achieve an optimal image. Move the

projector forward or backward if the edges of the image are

distorted.

• The projector lens should be centred in the middle of the

screen. If the lens centre is not perpendicular to the screen,

the image will be distorted, making viewing difficult.

• Position the screen so that it is not in direct sunlight or room

light. Light falling directly onto the screen washes out

colours, making viewing difficult. Close the curtains and dim

the lights when setting up the screen in a sunny or bright

room.

• A polarising screen cannot be used with this projector.

• Place the projector at the required distance from the screen

according to the desired picture size (see the table below).

• Optional wide and telephoto lenses from Philips are available

for specialised application. Please see your local Philips

Authorised LCD Projector Dealer for details on the optional

lenses.

Standard mode (4:3)

Image size Projection distance Distance lens

(diag.) Tele zoom Wide zoom center to bottom

of image

mtrs inch mtrs inch mtrs inch cm inch

1,02 40 1,40 55 1,90 75 3,10 1,22

1,52 60 2,20 87 2,90 114 4,60 1,81

1,83 72 2,60 102 3,40 134 5,50 2,17

2,13 84 3,10 122 4,00 157 6,40 2,52

2,54 100 3,70 146 4,90 193 7,60 2,99

3,81 150 5,60 220 7,20 283 11,40 4,49

5,08 200 7,40 291 9,80 386 15,20 5,98

7,62 300 11,00 433 14,30 563 22,90 9,02

Wide mode (16:9)

Image size Projection distance Distance lens

(diag.) Tele zoom Wide zoom center to bottom

of image

mtrs inch mtrs inch mtrs inch cm inch

1,02 40 1,50 59 2,00 79 -5,00 -1,97

1,52 60 2,40 94 3,10 122 -7,50 -2,95

1,83 72 2,80 110 3,70 146 -9,00 -3,54

2,13 84 3,30 130 4,30 169 -10,50 -4,13

2,34 92 3,70 146 4,80 189 -11,50 -4,53

2,54 100 4,00 157 5,20 205 -12,50 -4,92

2,69 106 4,30 169 5,60 220 -13,20 -5,20

3,38 133 5,40 213 7,00 276 -16,60 -6,54

3,81 150 6,10 240 7,90 311 -18,70 -7,36

5,08 200 8,10 319 10,50 413 -24,90 -9,80

7,62 300 12,0 472 15,60 614 -37,40 -14,72

Notes:

– Tolerances ± 3% in above mentioned values.

– Values with a minus (-) sign indicate the distance of the lens

centre below the bottom of the screen.

MAINS SUPPLY

1. Insert the mains lead into the projectors Power socket and

connect it to the wall socket.

Note:

The Power indicator lights up red, the projector is now in the

Power/Standby mode.

2. Remove the lens cap.

3. Press Power On.

• The power indicator lights up green and the flashing green

Lamp indicator shows that the lamp is warming up. Wait

until the indicator stops flashing before operating the

projector. The image shown is the Philips start-up screen

(default setting).

• If the power is turned off and then immediately turned on

again, it may take a short while before the lamp turns on.

• After the projector is unpacked and turned on for the first

time, a slight odour may be emitted from the exhaust vent.

This odour will soon disappear with use.

When the power is on, the Lamp indicator lights indicating the

status of the lamp.

Green: lamp is ready.

Flashing green: warming up.

Red: change the lamp.

4. To switch off the mains supply completely, pull the mains

plug out of the wall socket.

Note:

Before disconnecting the mains lead, make sure that the

cooling fan has stopped (about 2 minutes after the projector

has been switched off).

ADJUSTING THE VERTICAL AND HORIZONTAL ANGLE OF

THE PROJECTOR

Using the adjustment feet

• Press foot releases.

• Adjust height of projector and remove hands from foot

releases.

• Rotate feet to make fine adjustments.

• The projector is adjustable up to approximately 5° from the

standard position.

• When the height of the projector is adjusted, the image

may become distorted (keystoned),

depending on the relative positions of the

projector and the screen.

(See ‘Lens adjustment’).

CAUTION!

– Do not press the foot releases when the adjustment feet are

extended without firmly holding the projector.

– Do not hold the lens when lifting or lowering the projector.

– When lowering the projector, be careful not to get your

fingers caught in the area between the adjustment feet and

the projector.

Keystoned Image

))

6. SET UP

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips lc1041 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info