Bedienungsanleitung Philips PPX 2340 (Seite 4 von 25) (Englisch)

577591

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

4 Philips · PPX2330 · 2340

1 General Safety Information

Do not make any changes or settings that are not

described in this user manual. Physical injury or damage

to the device or loss of data can result from improper

handling. Take note of all warning and safety notes indi-

cated.

Setting Up the Device

The device is exclusively for indoor use. The device

should be placed securely on a stable, flat surface. Posi-

tion all cables in such a way that no one will trip on

them, thus avoiding possible injuries to persons or dam-

age to the device itself.

Do not plug in the device in humid rooms. Never touch

the electrical cable or the electrical connection with

wet hands.

The device must have sufficient ventilation and should

not be covered. Do not put your device in closed cabi-

nets or boxes.

Do not place the device on soft surfaces such as table-

cloths or carpets and do not cover the ventilation slits.

Otherwise the device could overheat or catch fire.

Protect the device against direct sunlight, heat, large

temperature fluctuations and moisture. Do not place

the device in the vicinity of heaters or air conditioners.

Observe the information on temperature and humidity

in the technical data.

When the device is running for a long period of time,

the surface becomes hot and a warning symbol appears

on the projection. The device switches automatically to

ECO mode when it gets too hot (see also chapter

Power Save, page 18).

Do not allow liquids to enter into the device. Switch off

the device and disconnect it from the power supply if

liquids or foreign substances end up inside the device.

Have the product inspected by an authorized service

center.

Always handle the product with care. Avoid touching

the lens. Never place heavy or sharp objects on the pro-

jector or the power cable.

If the projector gets too hot or emits smoke, shut it

down immediately and unplug the power cable. Have

your device examined by trained professionals at an

authorized service center. To prevent the spread of fire,

open flames should be kept away from the device.

Under the following conditions, a layer of moisture can

appear inside the device which can lead to malfunctions:

· if the device is moved from a cold to a warm area;

· after a cold room is heated;

· when this device is placed in a damp room.

Proceed as follows to avoid any moisture build-up:

1 Seal this device in a plastic bag before moving it to

another room, in order for it to adapt to room con-

ditions.

2 Wait one to two hours before you take the device

out of the plastic bag.

The device should not be used in a very dusty environ-

ment. Dust particles and other foreign objects may

damage the product.

Do not expose the device to extreme vibrations. It may

damage the internal components.

Do not allow children to handle the device without

supervision. The packing materials should be kept out of

the hands of children.

Repairs

Do not make any repairs to the device yourself.

Improper maintenance can result in injuries or damage

to the device. Have your device repaired only by an

authorised service centre.

Do not remove the type label from your device; this

would void the warranty.

Power Supply

Use only the enclosed power adapter (see chapter Appen-

dix / Technical Data). Check whether the electrical voltage

of the power supply matches the electrical voltage available

at the setup location. This equipment complies with the

voltage type specified on the product.

The product should be supplied by a power system com-

pliant with LPS requirements of 2.5 of UL60950-1.

The capacity of the battery diminishes with time. If the

device functions only with the power supply, the battery

is defective.

Do not try to replace the battery yourself. Incorrect

handling of the battery or using the wrong type of bat-

tery can cause damage to the device or cause injury.

Batteries (battery pack or batteries installed) must not

be exposed to flame or excessive heat including from

direct sunshine or the like.

Attention should be drawn to the environment aspects

of battery disposal.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips PPX 2340 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips PPX 2340

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info