Bedienungsanleitung Philips-Saeco Armonia SINO024X (Seite 23 von 92) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

459483

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

ENGLISH

• 23 •

4 INSTALLATION

For your own safety and the safety of

others, you must strictly comply with the

“Safety Rules” described in section 3.

4.1 Packaging

The original packaging was designed and

made to protect the machine during shipping.

We recommend keeping it for future transport

purposes.

4.2 Installation precautions

Before installing the machine, make sure to

follow these safety precautions:

• put the machine in a safe place;

• make sure that children are not allowed to

play with the machine;

• avoid placing the machine on very hot

surfaces or near open flames.

Now the coffee machine is ready to be

connected to the mains power supply.

4.3 Mains connection

Electricity can be dangerous! There-

fore, always strictly abide by the

safety rules.

Never use defective cords!

Defective cords and plugs must be

immediately replaced by an Authorised

Service Centre.

The coffee machine must be plugged into a

suitable electric socket.

The voltage of the appliance is factory set.

Check that the mains voltage matches the

rating specified on the identification plate on

the bottom of the appliance.

• Before plugging in the machine, make sure

the ON/OFF switch is not pressed (2).

• (Fig.4A) - Put the socket into the outlet on

the rear of the machine.

• Connect the other socket to a wall outlet

having the proper voltage.

4.4 Filling the water tank

• (Fig.1) - Remove the water tank (1) taking

care not to damage the water suction tube.

• (Fig.2) - Rinse out the tank and fill it with fresh

drinking water, taking care not to overfill.

• (Fig.3) - Fit the tank again in its position,

and place the tube previously removed.

Always fill the tank with fresh, still

drinking water.

Hot water and/or other liquids may dama

ge the tank. Always make sure that there is

sufficient water in the tank before starting

the machine.

4.5 Loading the circuit

Before starting the machine, if it has been

inoperative for a long time and all the water has

been used up, you must reload the circuit.

• (Fig.4B) - Press the ON/OFF switch (2). The

light (3) will go on.

• (Fig.5) - Place a container beneath the steam

tube. Turn the “hot water/steam” knob (7)

counterclockwise to open.

• (Fig.6) - Press the coffee switch (4).

• Wait until a steady stream of water flows from

the steam tube (“pannarello”).

• Press the coffee switch (4) again. Turn the

“hot water/steam” knob (7) clockwise to shut

off flow (Fig.7). Remove the container.

The machine is now ready to dispense coffee

and steam; for a description of machine

functions, see the specific sections.

5 MAKING COFFEE

Warning!

While the brew unit is operating it

is forbidden to remove the “Crema” filter

holder by manually turning it clockwise.

Danger of burns!

• During this operation the temperature ready

light (5) may go on and off; this is normal

and not to be considered a fault.

Installation

4316036000 - SIN024X Rev00.indd 23 10/05/2004 11.57.18

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips-Saeco Armonia SINO024X Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info