Bedienungsanleitung Philips-Saeco SM7786 Xelsis (Seite 15 von 128) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

711389

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

4 Disassemble all parts (Fig. 32) and clean them under the tap.

5 Reassemble the internal cappuccinatore.

6 To place back the internal cappuccinatore, put it in upright position and make sure the holes are

aligned with the two tubes on the machine. Then move the internal cappuccinatore upwards until it

locks into place (Fig. 33).

7 Close the door.

Visit www.saeco.com/care for detailed video instructions.

Descaling procedure

Please use Philips descaler only. Under no circumstances should you use a descaler based on sulfuric

acid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water circuit in your

machine and not dissolve the limescale properly. Not using the Philips descaler will void your

warranty. Failure to descale the appliance will also void your warranty. You can buy Philips descaling

solution in the online shop at www.saeco.com/care.

1 When the machine asks you to descale it, press the start/stop

button to start. To start descaling

without being prompted by the machine, tap the Clean icon and select 'Descale' (Fig. 34).

2 Remove the drip tray and the coffee grounds container, empty them and put them back into place.

3 Remove the water tank and empty it. Then remove the AquaClean filter.

4 Pour the whole bottle of Philips descaler in the water tank and then fill it with water up to the CALC

CLEAN level. Then place it back into the machine.

5 Place a large container (1.5 l) under the coffee dispensing spout.

6 Follow the instructions on the screen to start the descaling procedure. The descaling procedure

lasts approx. 15 minutes and consists of a descaling cycle and a rinsing cycle.

7 Once the descaling cycle is finished, you need to rinse the water tank and water circuit. Follow the

instructions on the screen.

8 Place a new AquaClean filter in the water tank and reactivate the AquaClean filter in the menu.

Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

You can exit the descaling procedure by pressing the on/off button on the control panel. If the

descaling procedure is interrupted before it is completely finished, do the following:

1 Empty and rinse the water tank thoroughly.

2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machine

back on. The machine will heat up and perform an automatic rinsing cycle.

3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first

dispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without adding

ground coffee.

Note: If the descaling procedure was not completed, the machine will require another descaling

procedure as soon as possible.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips-Saeco SM7786 Xelsis Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info