Bedienungsanleitung Philips-Saeco SM8889 - Xelsis Suprema (Seite 18 von 686) (Alle Sprachen)

775969

Zoom out

Zoom in

Vorherige Seite

1/686

Nächste Seite

16 English

5Reassemble the internal cappuccinatore.

6To place back the internal cappuccinatore, put it in upright position and make sure the holes are

aligned with the two tubes on the machine. Then move the internal cappuccinatore upwards until it

locks into place (Fig. 1).

7Close the door.

Visit www.saeco.com/care for detailed video instructions.

Descaling procedure

Please use Philips descaler only. Under no circumstances should you use a descaler based on sulfuric

acid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water circuit in your

machine and will not dissolve the limescale properly. Not using the Philips descaler will void your

warranty. Failure to descale the appliance will also void your warranty. You can buy Philips descaler

from your local or online retailer or from authorized service centers.

1When the machine asks you to descale it, tap the confirmation icon to start. To start descaling

without being prompted by the machine, tap the 'Status' icon and select 'Descale'.

2Remove the drip tray, the coffee grounds container and the HygieSteam container (Fig. 26), empty

them and put them back into place.

3Remove the water tank and empty it. Then remove the AquaClean filter.

4Pour the whole bottle of Philips descaler into the water tank and then fill it with water up to the

CALC CLEAN level (Fig. 41). Then place the water tank back into the machine.

5Place a large container (1.5 l) under the coffee dispensing spout.

6Make sure that the HygieSteam container is correctly assembled (Fig. 34) and attached to the

machine (Fig. 35). Place the milk tube in the milk tube holder.

7Follow the instructions on the screen to start the descaling procedure. The descaling procedure

lasts approx. 30 minutes and consists of a descaling cycle and a rinsing cycle.

8Once the descaling cycle is finished, you need to rinse the water tank and water circuit. Follow the

instructions on the screen.

9Place a new AquaClean filter in the water tank and activate it (see 'Activating the AquaClean water

filter (5 min.)').

Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

You can exit the descaling procedure by pressing the on/off icon on the control panel. If the descaling

procedure is interrupted before it is completely finished, some descaling liquid may remain in the

water tank or the water circuit. In that case, do the following:

1Empty and rinse the water tank thoroughly.

2Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machine

back on. The machine will heat up and perform an automatic rinsing cycle.

3Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first

dispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without adding

ground coffee.

Note: If the descaling procedure was not completed, the machine will require another descaling

procedure as soon as possible.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips-Saeco SM8889 - Xelsis Suprema Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info