Bedienungsanleitung Philips SC1991 (Seite 16 von 134) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

527155

Zoom out

Zoom in

Vorherige Seite

1/134

Nächste Seite

Follow steps 2-6 of the previous section (‘Before rst use and skin test’).

Note: It is normal that the appliance and the body attachment become warm

during use.

4 Slide the appliance over the skin to the next area to be treated

and repeat steps 5 and 6 of section ‘First use and skin test’ in this

chapter. After each ash, it takes up to 3.5 seconds until the appliance 

is ready to ash again. The ‘ready to ash’ light on the back of the 

appliance starts blinking again to indicate that it is charging. Wait until

this light lights up continuously before you continue.

Tip for SC1992: The SC1992 has a ‘slide and ash’ feature: for a more efcient

treatment, keep the ash button pressed while you slide the appliance over

your skin.

Do not treat exactly the same area multiple times during one session.

This does not improve the effectiveness of the treatment, but increases 

the risk of skin reactions.

5  To avoid untreated areas, make sure the ashes are produced close 

to each other. Note that effective light only comes out of the light

exit window. However, always make sure you do not ash the same 

area twice.

6  When you have nished the treatment, press and hold the on/off 

button for 2 seconds to switch off the appliance.

7 Check the light exit window and the body attachment for hairs and

dirt and clean the appliance after use (see chapter ‘Cleaning and

maintenance’).

Tips

How to achieve optimal results

- It is normal that hairs are still visible after the rst few treatments (see

chapter ‘Introduction’, section ‘Working principle’ for more information).

- To remove all hairs successfully and prevent the hair follicle from

becoming active again, the treatments have to be repeated once every

two weeks for the rst two months. Your skin should be smooth and

hair-free by then. Please read section ‘Maintenance phase’ to nd out

how you can keep these results.

Maintenance phase

- To ensure that your skin stays smooth and hair-free, we advise you

to repeat the treatment every four to six weeks. The time between

treatments may vary based on your individual hair regrowth and also

across different body areas. If too many hairs grow back between

treatments, simply shorten the treatment interval again, but do not

treat any area more often than once every two weeks. When you use

the appliance more frequently than recommended, you do not increase

the effectiveness but you do increase the risk of skin reactions.

ENGLISH16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips SC1991 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips SC1991

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info