Bedienungsanleitung Philips SC2006 (Seite 22 von 114) (Deutsch, Italienisch)

537196

Zoom out

Zoom in

Vorherige Seite

1/114

Nächste Seite

Tip: To achieve optimal results on your underarms, stand in front of a mirror to

get a good view of the area to be treated and the ‘ready to ash’ light. Raise

your arm and place your hand in your neck to stretch the skin in the underarm

area. In this way the safety ring can be pressed more easily onto the skin,

which makes the treatment easier to perform.

Note: The reected light does not harm your eyes. If the scattered light is

unpleasant, close your eyes when you release a ash.

Using the appliance on the face (upper lip, chin, sideburns)

Check the recommended light intensities table in chapter ‘Preparing for

use’, section ‘Setting the light intensity’ to see which settings are suitable for

your face (upper lip, chin, sideburns).

Always use only the facial attachment to treat the upper lip, chin and

sideburns. Never use the appliance around the eyes or near the eyebrows.

When you treat your upper lip, chin or sideburns, make sure you do not

expose your face to direct sunlight in the 24 hours following the treatment.

Apply a sunblock (SPF 30+) after the treatment for the next two weeks

when you expose your face to direct sunlight.

Tip: To achieve optimal results on your upper lip, chin and sideburns stand in

front of a mirror to get a good view of the area to be treated and the ‘ready to

ash’ light.

Tip: Apply a thick layer of white eyeliner to your lip and lip margin. This white

line ensures the energy of the ash is reected and does not touch your lip if

you ash the lip unintentionally.

Tip: Because of the contours of the jaws, it may be difcult to bring the safety

ring into full contact with the skin and to release a ash. Put your tongue

between your teeth and upper lip or puff up your cheeks to make this easier.

Tip: The reected light does not harm your eyes. If the scattered light is

unpleasant, close your eyes when you release a ash.

How to achieve optimal results

- It is normal that hairs are still visible after the rst few treatments (see

chapter ‘Introduction’, section ‘Working principle’ for more information).

- To remove all hairs successfully and prevent the hair follicle from

becoming active again, the treatments have to be repeated once every

two weeks for the rst two months. Your skin should be smooth by

then. Please read section ‘Maintenance phase’ to nd out how you

can keep these results.

Maintenance phase

- To ensure that your skin stays smooth, we advise you to repeat the

treatment every 4 to 8 weeks. The time between treatments may vary

based on your individual hair regrowth and also across different body

areas. If too many hairs grow back between treatments, simply shorten

the treatment interval again, but do not treat any area more often than

once every two weeks. When you use the appliance more frequently

than recommended, you do not increase the effectiveness but you do

increase the risk of skin reactions.

ENGLISH22

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips SC2006 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips SC2006

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info