Bedienungsanleitung Philips scd 470 (Seite 10 von 96) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

368305

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite





Only replace the non-rechargeable batteries of the parent unit with four 1.5V R6 AA batteries.

Note: We strongly advise you to use Philips non-rechargeable batteries.



Only replace the adapter of the parent unit with an adapter of the original type. You can order a

new adapter from your dealer or a Philips service centre:

- TAD1-0900200E01 / SVH-005-090-020-A1 (EU/SGP only)

- 9VD200 (AU/NZ only)



- Do not throw away the appliance with the normal household waste at the end of its life, but

hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the

environment (Fig. 9).

- Batteries contain substances that may pollute the environment. Always remove the batteries

before discarding the appliance or handing it in at an ofcial collection point. Dispose of the

batteries at an ofcial collection point for batteries (Fig. 10).



If you need service or information or if you have a problem, please visit the Philips AVENT website

at or contact the Philips Consumer Care Centre in your country (you

can nd the phone number in the worldwide guarantee leaet). If there is no Consumer Care

Centre in your country, go to your local Philips dealer.



This chapter lists the questions most frequently asked about the appliance. If you cannot nd the

answer to your question, contact the Consumer Care Centre in your country.

Question Answer

Why can’t I establish a

connection?

The units may be set to different channels. Set both units to the same

channel and wait 10-30 seconds for the connection to be established.

The baby unit may be out of range of the parent unit or there may be

too many walls and/or ceilings between the two units. Try a different

location or reduce the distance between the two units.

Why is the connection

lost every now and

then?

The baby unit may be out of range of the parent unit or there may be

too many walls and/or ceilings between the two units. Try a different

location or reduce the distance between the two units.

Why do I hear noise

or a scratching sound?

There may be interference from another appliance or baby monitor.

Switch both units to another channel. Make sure both units are set to

the same channel.

The parent unit may be too close to a window, causing it to pick up

signals from other appliances or baby monitors. Move the unit away from

the window.

10

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips scd 470 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info