Bedienungsanleitung Philips scd481 00 (Seite 10 von 152) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

368395

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite



You can adjust the volume on the parent unit to suit your surroundings.

1 Turn the volume control of the parent unit to the volume you prefer (Fig. 18).

Note: When the volume on the parent unit is set to a high level, it consumes more power.



The parent unit continuously monitors the sound level in your baby´s room and the sound level

lights let you know if there is any activity. If your baby cries, you see the sound level lights light up on

the parent unit.

- As long as the baby unit does not detect a sound, all sound level lights on the parent unit are

out.

- When the baby unit picks up a sound, one or more sound level lights on the parent unit go on.

How many lights go on depends on the loudness of the sound picked up by the baby unit.

- The sound level lights also operate when the parent unit is set to a low volume.



The baby unit has a gentle nightlight that helps to soothe your baby back to sleep.

1 Press the baby unit nightlight to switch the nightlight on and off (Fig. 19).



Always make sure that the channel selectors inside the compartments of both units are set to the

same channel. With these channel selectors, you can select sixteen different channel positions. If you

experience interference from other baby monitors, radios, TVs etc. that use the same channel, select

a different channel.

1 Remove the lids of both units.

, Baby unit: (Fig. 3)

- Insert a coin or screwdriver into the groove of the locking knob (1), turn the locking knob

anticlockwise (2) and remove the lid.

- If there are batteries in the compartment, remove them.

, Parent unit: (Fig. 5)

- Slide the lid downwards to remove it.

- Remove the battery pack from the compartment.

2 Use a small, at screwdriver to turn the channel selector of each unit to the desired position.

Make sure both units are set to the same channel (Fig. 20).

3 Test the connection

If you do not experience any interference when you test the connection, put the battery pack and

the non-rechargeable batteries back into the compartments and reattach the lids.

If you experience interference, set the selectors of both units to another channel and test the

connection again.





If the battery pack of the parent unit is sufciently charged, you can take the unit with you inside and

outside the house if you attach the unit to your belt or waistband with the belt clip. This allows you

to monitor your baby while you are moving around.

10

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips scd481 00 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info