Bedienungsanleitung Philips SCN650 Screeneo S6 (Seite 26 von 28) (Englisch)

706806

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Appendix 25

CE statement

• The product shall only be connected to a

USB interface of version USB 2.0 or higher.

• Adapter shall be installed near the

equipment and shall be easily accessible.

• The operating temperature of the EUT can’t

exceed 35°C and shouldn’t be lower than

5°C.

• The plug is considered as disconnect device

of adapter.

• The UNII Band 5150-5250 MHz is for indoor

use only.

• The device complies with RF speciﬁcations

when the device is used at 20 cm from your

body.

Hereby, Screeneo Innovation SA declares that

this product is in compliance with essential

requirements and other relevant provisions of

Directive 2014/53/EU.

The Declaration of Compliance can be

consulted on the site www.philips.com.

Frequency bands Maximum output

power

BT EDR (EIRP) 9.09 dBm

BT BLE (EIRP) 4.85 dBm

WiFi 2.4GHz (EIRP) 17.88 dBm

WiFi 5GHZ (EIRP) 17.89 dBm

FCC statement

15�19 Labeling requirements�

This device complies with part 15 of the FCC

Rules. Operation is subject to the following

two conditions: (1) This device may not cause

harmful interference, and (2) this device must

accept any interference received, including

interference that may cause undesired

operation.

15�21 Information to the user�

Any changes or modiﬁcations not expressly

approved by the party responsible for

compliance could void the user’s authority to

operate the equipment.

15�105 Information to user�

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in

a residential installation. This equipment

generates, uses and can radiate radio

frequency energy and, if not installed and used

in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause harmful interference

to radio or television reception, which can be

determined by turning the equipment oﬀ and

on, the user is encouraged to try to correct the

interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on

a circuit diﬀerent from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/

TV technician for help.

During operation, the separation distance

between the user and the antenna shall be

at least 20 cm. This separation distance will

ensure that there is suﬃcient distance from a

properly installed externally-mounted antenna

to satisfy the RF exposure requirements.

FCC ID: 2ASRT-SCN650

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips SCN650 Screeneo S6 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Philips SCN650 Screeneo S6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info