Bedienungsanleitung Philips shb 1300 (Seite 4 von 26) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

228305

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Using your headset

Wearing your Bluetooth headset

Wearing options

The Bluetooth headset can be attached to your garm-

ent with the metal clip or be worn around the neck.

To change from clip on style to necklace style, attach

the neck strap in three steps:

1. Attach the Y-connector (S6) to the earplug cable

close to Bluetooth device.

2. Attach the slider (S5) to the earplug cable beneath

the clip (S4).

3. Fix the slider position by attaching the clip (S4) to

the earplug cable.

You can detach the neck strap from the earplug cable

at any time.

Redialing the last dialed number

Rejecting incoming calls

Adjusting speaker volume

(Available if supported by your mobile phone)

To redial the last dialed number, press and hold the volume down key S3 for 2

seconds. A short low tone will indicate an attempt to redial.

(Available if supported by your mobile phone)

To reject an incoming call, press the multi function button S1 and hold it until you

hear a long beep tone, then release it.

During a call:

Press and release S2 to increase the speaker volume and

Press and release S3 to decrease the speaker volume.

A key tone will indicate any increase or decrease of the volume. A higher pitch

signal tone will alert you when the volume level reaches its maximum or minimum.

●

Answering incoming calls

The HS will ring when a call comes in. Press the multi function button S1 to

answer the call. The green LED will flash fast (once a second) while the call is in

progress.

Transferring calls (Available if supported by your mobile phone)

During your call, calls can be transferred from the Bluetooth phone to the HS

and from the HS to the Bluetooth phone.

To transfer a call from HS to the Bluetooth phone, please follow the operating

instructions of your phone.

To transfer a call from the Bluetooth phone to the HS: press S1 once; the call wil

be transferred to the HS.l

Muting the microphone

To mute the microphone during an active call:

Press the volume control buttons S2 and S3 simultaneously for about a second.

A periodic beep tone will be heard while the mute function is active.

●

To end the mute function:

●Press the volume control buttons S2 and S3 simultaneously. The periodic beep

tone will stop.

Ending calls

Press S1 to end an ongoing call. After the call is disconnected, the green LED

will flash once every three seconds.

Voice dialing (Available if supported by your mobile phone)

1. Make sure the voice dialing function is properly set up in your mobile phone.

2. Press the multi function button S1 on the HS shortly.

3. After hearing the voice dial signal (four tones low to high pitch), say the name

of the person as recorded in your mobile phone. The call will be connected within

a few seconds.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Philips shb 1300 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info