Automatically setting the remote control
If you cannot find the right code for your brand device, the remote
control can automatically search for the right code.
1 Make sure the TV is switched on and select a channel using
the original remote control or the keys on the TV (for
example channel 1).
2 Keep keys 1 and 3 on the SRP 1001
SRP 1001 pressed simultaneously for
five seconds, until the indicator light
remains lit.
3 Press the y key of the SRP 1001 .
and keep it pressed
– The SRP 1001 now starts emitting
all known ‘TV off’ signals, one by
one. Each time a code is sent, the
indicator light flashes.
4 When your TV switches off
(stand-by), immediately release the
y key of the SRP 1001 to confirm.
– The SRP 1001 has now found a
code that works on your TV.
5 Check if you can operate all
functions on your TV with the SRP 1001.
• If this is not the case, you can redo the automatic
setting. The SRP 1001 will then search for a code that
perhaps works better.
– After the SRP 1001 has run through all the known codes, the
search will stop automatically and the indicator light stops
flashing.
– Automatic programming of a TV takes a maximum of 6
minutes.
5
English
Installing the remote control
EN
5 sec.
