4 Press and hold the Standby key
of the SRU 5020.
– The SRU 5020 now starts emitting all known
‘TV off’ signals, one by one.
Each time a code is sent, the TV key lights up.
5 When your TV switches off (stand-by), release the Standby key of the
SRU 5020 immediately.
– The SRU 5020 has now found a code that works on your TV.
6 Check if you can operate all functions on your TV with the SRU 5020.
• If this is not the case, you can redo the automatic setting.
The SRU 5020 will then search for a code that works better.
– After the SRU 5020 has run through all the known codes, the search
will stop automatically and the TV key stops flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
For DVD or VCR this time is 2 minutes.
Manually setting the remote control
Example of TV:
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the
code list at the back of this manual.
One or more four-figure codes are shown for
each brand.
Note the first code.
Be careful! There are separate tables for TV, DVD
and VCR.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
3 Press the TV key to select TV.
Press the key until it lights up.
4 Keep keys 1 and 3 pressed simultaneously
for three seconds until the TV key flashes
twice and then remains lit.
6
Instructions for use
English
