4 Press and hold the Standby key of
the SRU 7060 briefly.
– The SRU 7060 now starts emitting all known
‘TV off’ signals, one by one.
Each time a code is sent, the light around the
Standby key lights up.
5 When your TV switches off (standby),
release the Standby key of the SRU 7060
immediately.
– The SRU 7060 has now found a code that
works on your TV.
6 Check if you can operate all functions on your TV with the SRU 7060.
• If this is not the case, you can redo the automatic setting.The
SRU 7060 will then search for a code that perhaps works better.
– After the SRU 7060 has run through all the known codes, the search
will stop automatically and the light will stop blinking.
– Automatic programming of a TV takes a maximum of 3 minutes.
For DVD, CD,VCR, AMP and STB this time is 2 minutes.
Manually setting the remote control
Example TV:
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the
code list at the back of this manual. One or
more four-figure codes are shown for each
brand.
Note the first code.
Be careful! There are separate tables for TV,VCR,
DVD, etc.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
3 Select the device mode TV with the
SELECT key. Press the SELECT key until the
light around the Standby key lights up.
5
Instructions for use
English
