Bedienungsanleitung Piazzetta P960 (Seite 23 von 64) (Englisch)

643476

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Power cable (6)

•The stove/rebox comes with a power cable which must be connected

to a 120V AC electrical outlet mains socket. Connection to the rear of

the stove/rebox is shown in g. 42.

•The power rating is indicated in the paragraph “TECHNICAL DATA”.

a The appliance must be connected to an efcient earthing/

grounding system.

a Any stove installed in a mobile home must be electrically

grounded to the steel chassis of the home and bolted to the

oor in Model compliance with, and according to building

code requirements.

a Ensure that in its normal position the power cable does not

come into contact with any heated parts.

a Ensure that the electrical plug is accessible also after

installation of the stove.

a In Canada, the electrical installation must meet the appliance

requirements for CSA C22.2

Room sensor connection (5)

•When installing the stove/rebox, it is necessary to connect the room

sensor (provided) to the correct jack (Fig. 40). The sensor can be

positioned as shown in g. 41, otherwise remove the band, uncoil the

lead and then place the sensor in a spot where a more accurate room

temperature reading can be obtained.

Pipe tap (3)

•The appliance has an external socket for measuring the pressure

(vacuum) of the ue gas outlet pipe. This control and verication should

be carried out by authorised personnel at the time of installation or

during maintenance.

Connection to the DB9 serial socket (7)

•The appliance has a DB9 serial socket, which is used to check

appliance operation. Controls should be carried out by authorised

personnel at the time of installation or during maintenance.

Fig. 40

1 External jack for connection of

room sensor

2 Socket for power lead

3 Pipe tap

4 Knockout for inserting cable gland

PG7 for connection of external

thermostat

Fig. 41 Fig. 42

5 Room sensor connection

6 Power lead connection

7 DB9 serial socket

DT2010146-00

5.2 ELECTRICAL CONNECTIONS ANd CONTROLS

The appliance is designed for connection to an external room thermostat

(not included in the package).

To connect the thermostat use a 2x0.5 mm

cable secured with a PG7

cable gland to be inserted in the relative hole in the rear panel (Fig. 40).

Only authorised personnel should carry out this operation.

a Installation can be carried out with any type of room thermostat

but requires a PG7 cable gland similar to that shown in g. 44.

To connect the room thermostat to the electronic board, refer

to the wiring diagram.

To install, proceed as follows:

- cut off the electricity to the appliance before opening it;

- remove the electronic board protective panel (Fig. 44);

- remove the knockout to be found in the rear panel (position 4 – gure

40);

- clamp the thermostat cable with the PG7 cable gland and insert the

gland into the hole in the rear panel (Fig. 45);

- connect the thermostat terminal to the 2-pin terminal of the electronic

board (see WIRING DIAGRAM);

- replace the electronic board protective panel.

DT2010147-03

5.3 INSTALLING ThE ExTERNAL ThERMOSTAT

Fig. 43

1 Thermostat

2 Electronic board 2-pin terminal

3 Cable gland PG 7

4 Thermostat cable terminal

ELECTRONIC BOARD

PROTECTIVE PANEL

Fig. 44 Fig. 45

H07028100/DT2000970 – 01

English

DT2030224-01

DT2030225-01 DT2030226-01

DT2030076-00

DT2030227-01 DT2030228-00

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Piazzetta P960 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info