643476
49
Zoom out
Zoom in
Vorherige Seite
1/64
Nächste Seite
DT2010994-00
6.19 SAFETy dEvICES
a During operation some parts of the stove (door, handle, ceramic parts) can reach high temperatures.
Remember to maintain the safety distances indicated previously.
Be careful, take all due precautions and always comply with the instructions.
If during operation smoke leaks from any part of the stove or the ue, shut the stove down immediately and ventilate the room. When the stove has
cooled, check for the cause of the leak and if necessary call in specialist personnel.
The stove is tted with several safety devices to guarantee safe operation.
a The safety devices are tted to eliminate the risk of injury to people and pets and damage to property. Tampering or work carried out
by unauthorised personnel can jeopardise this function.
Possible warnings of problems
Simple operating problems can usually be resolved with the help of the following pages.
SMOKE CHAMBER PRESSURE
Sensor Description Display
Pressure switch
ALF 1”
Connected to the ue gas outlet, its function is to control the vacuum
inside the outlet duct so that the stove can be used in all safety.
WHEN ACTIVATED
If correct operating conditions in the ue gas outlet change (incorrect
installation, blockages or obstructions in the ue, poor maintenance,
unfavourable weather conditions such as persistent wind, etc.) the
pressure switch cuts off the power supply to the fuel-loading auger,
thereby stopping the supply of pellets to the grate and starting the stove
shutdown process.
•The readout “ALF 1 appears in the STOVE STATUS mode.
•The readout “SMOKE SAFETY “ appears on the display.
•After approx. 60 seconds the alarm sounds (if activated).
!
!
1
1
SAFETY
SMOKE
SAFETY
SMOKE
12:00 73F
12:00 73F
WHAT TO DO
•Shut down the stove by holding the ON/OFF key down for several
seconds.
•The alarm stops.
•Wait until you are sure that combustion of any pellets remaining in the
grate has stopped.
•Wait until the stove has cooled down, then check for and remove
whatever has caused the safety device to be triggered. Finally, after
having cleaned the grate restart the stove by pressing the ON/OFF key.
Pressure switch
ALF 2”
Its function is to check correct operation of the pressure switch so that the
stove can be used in all safety.
WHEN ACTIVATED
It activates during the “START” stage of the stove (see “STARTING THE
STOVE” table).
If an anomaly is detected in the pressure switch, the readout “ALF 2
appears in the STOVE STATUS mode.
The readout “SMOKE SAFETY appears on the display.
After approx. 60 seconds the alarm sounds (if activated).
!
!
1
1
SAFETY
SMOKE
SAFETY
SMOKE
12:00 73F
12:00 73F
WHAT TO DO
•Shut down the stove by holding the ON/OFF key down for several
seconds.
•The alarm stops.
•Call the After-Sales Service Centre. DT2040095-00
H07028100/DT2000970 – 01
49
English
49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Piazzetta P960 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info