Bedienungsanleitung Piazzetta P963 M (Seite 26 von 72) (Englisch)

643487

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Power cable (6)

• The stove/replace comes with a power cable which must be

connected to a 120V AC electrical outlet mains socket. Connection to

the rear of the stove/replace is shown in g. 43.

• The power rating is indicated in the paragraph “TECHNICAL DATA”.

a The appliance must be connected to an efcient earthing/

grounding system.

a Any stove installed in a mobile home must be electrically

grounded to the steel chassis of the home and bolted to the

oor in Model compliance with, and according to building

code requirements.

a Ensure that in its normal position the power cable does not

come into contact with any heated parts.

a Ensure that the electrical plug is accessible also after

installation of the stove.

a In Canada, the electrical installation must meet the appliance

requirements for CSA C22.2

Room sensor connection (5)

• When installing the stove/replace, it is necessary to connect the

room sensor (provided) to the correct jack (Fig. 41). The sensor can be

positioned as shown in g. 42, otherwise remove the band, uncoil the

lead and then place the sensor in a spot where a more accurate room

temperature reading can be obtained.

Pipe tap (3)

• The appliance has an external socket for measuring the pressure

(vacuum) of the ue gas outlet pipe. This control and verication should

be carried out by authorised personnel at the time of installation or

during maintenance.

Connection to the DB9 serial socket (7)

• The appliance has a DB9 serial socket, which is used to check

appliance operation. Controls should be carried out by authorised

personnel at the time of installation or during maintenance.

DT2010146-00

5.2 ELECTRICAL CONNECTIONS AND CONTROLS

The appliance is designed to be connected to an external room thermostat

with normally closed contact (not supplied by the manufacturer).

To connect the thermostat use a 2x0.5 mm

cable secured with a PG7

cable gland to be inserted in the relative hole in the rear panel (Fig. 41).

Only authorised personnel should carry out this operation.

To install, proceed as follows:

- Disconnect the stove from the electrical power line.

- Access to the electronic board. It could be necessary to remove part

of the cladding (see INSTALLING /REMOVING THE CLADDING) and the

protective panel of the electronic board (if present).

- Remove the knockout to be found in the rear panel (position 4 – gure

41).

- Clamp the thermostat cable with the PG7 cable gland and insert the

gland into the hole in the rear panel (Fig. 46).

- Connect the thermostat cable terminal (C. - N.C. common - normally

closed contact) to a 2 PIN terminal and then insert this in the NH2O

position on the board as shown in gure 44.

- Pay attention to the wiring trail inside the stove which must not make

contact with hot or moving parts.

- Ret all the components previously removed.

a Do not connect any live element to the terminal, NH2O.

DT2010997-02

5.3 INSTALLING THE EXTERNAL THERMOSTAT

Fig. 41

1 External jack for connection of

room sensor.

2 Socket for power lead.

3 Pipe tap.

4 Knockout for inserting cable gland

PG7 for connection of external

thermostat.

Fig. 42 Fig. 43

5 Room sensor connection.

6 Power lead connection.

7 DB9 serial socket.

NH2O

Fig. 44

Fig. 45 Fig. 46

1 Thermostat

2 Electronic board 2-pin terminal

3 Cable gland PG 7

4 Thermostat cable terminal

H07032120 / DT2002308 – 00

English

DT2031447-00

DT2034323-00

DT2030076-00

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Piazzetta P963 M Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info