Bedienungsanleitung Pioneer AVH-190DVD (Seite 2 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

649353

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Precautions

Your new product and this manual

 Do not operate this product, any applications, or the rear

view camera option (if purchased) if doing so will divert your

attention in any way from the safe operation of your vehicle.

Always observe safe driving rules and follow all existing

traffic regulations. If you experience difficulty in operating

this product or reading the display, park your vehicle in a

safe location and apply the handbrake before making the

necessary adjustments.

 Do not install this product where it may (i) obstruct the driv-

er’s vision, (ii) impair the performance of any of the vehicle’s

operating systems of safety features, including airbags, haz-

ard lamp buttons, or (iii) impair the driver’s ability to safely

operate the vehicle. In some cases, it may not be possible to

install this product because of the vehicle type or the shape

of the vehicle interior.

 The graphical symbol

placed on the product means

direct current.

Important safeguards

WARNING

Pioneer does not recommend that you install this

product yourself. This product is designed for

professional installation only. We recommend that only

authorised Pioneer service personnel, who have special

training and experience in mobile electronics, set up and

install this product. NEVER SERVICE THIS PRODUCT

YOURSELF. Installing or servicing this product and its

connecting cables may expose you to the risk of electric

shock or other hazards, and can cause damage to this

product that is not covered by warranty.

Precautions before connecting

the system

WARNING

Do not take any steps to tamper with or disable the

handbrake interlock system which is in place for your

protection. Tampering with or disabling the handbrake

interlock system could result in serious injury or death.

CAUTION

 Secure all wiring with cable clamps or electrical tape.

Do not allow any bare wiring to remain exposed.

 Do not directly connect the yellow lead of this product

to the vehicle battery. If the lead is directly connected

to the battery, engine vibration may eventually cause

the insulation to fail at the point where the wire

passes from the passenger compartment into the

engine compartment. If the yellow lead’s insulation

tears as a result of contact with metal parts, short-

circuiting can occur, resulting in considerable danger.

 It is extremely dangerous to allow cables to become

wound around the steering column or gearstick. Be

sure to install this product, its cables, and wiring

away in such so that they will not obstruct or hinder

driving.

 Make sure that the cables and wires will not interfere

with or become caught in any of the vehicle’s moving

parts, especially the steering wheel, gearstick,

handbrake, sliding seat tracks, doors, or any of the

vehicle’s controls.

 Do not route wires where they will be exposed to

high temperatures. If the insulation heats up, wires

may become damaged, resulting in a short circuit or

malfunction and permanent damage to the product.

 Do not shorten any leads. If you do, the protection

circuit (fuse holder, fuse resistor or filter, etc.) may

fail to work properly.

 Never feed power to other electronic products by

cutting the insulation of the power supply lead of

this product and tapping into the lead. The current

capacity of the lead will be exceeded, causing

overheating.

Before installing this product

 Use this unit with a 12-volt battery and negative earthing

only. Failure to do so may result in a fire or malfunction.

 To avoid shorts in the electrical system, be sure to discon-

nect the (–) battery cable before installation.

To prevent damage

WARNING

 Use speakers over 50 W (output value) and between

4Ωto8Ω(impedancevalue).Donotuse1Ωto3Ω

speakers for this unit.

 The black lead is earth. Please earth this lead

separately from the earth of high-current products

such as power amps. Do not earth more than one

product together with the earth from another product.

For example, you must separately earth any amp

unit away from the earth of this product. Connecting

earths together can cause a fire and/or damage the

products if their earths became detached.

 When replacing the fuse, be sure to only use a fuse of

the rating prescribed on this product.

 This product cannot be installed in a vehicle without ACC

(accessory) position on the ignition switch.

ACC position No ACC position

 To avoid short-circuiting, cover the disconnected lead with

insulating tape. It is especially important to insulate all

unused speaker leads, which if left uncovered may cause a

short circuit.

 For connecting a power amp or other devices to this product,

refer to the manual for the product to be connected.

Notice for the blue/white lead

 When the ignition switch is turned on (ACC ON), a control

signal is output through the blue/white lead. Connect to an

external power amp’s system remote control terminal, the

auto-aerial relay control terminal, or the aerial booster power

control terminal (max. 300 mA 12 V DC). The control signal is

output through the blue/white lead, even if the audio source

is switched off.

Connection

< QRD3468-A >

Connection

Pioneer AVH-190DVD Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer AVH-190DVD

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info