Bedienungsanleitung Pioneer AVH-X3600DAB (Seite 69 von 100) (Englisch)

649366

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

! Ground – When the polarity of the con-

nected lead is negative while the shift lever

is in REVERSE (R) position

! Off – When a rear view camera is not con-

nected to this unit

! The rear view key setting also turns off on

the home display screen.

Auto EQ (auto-equalizing)

The auto-equalizer automatically measures

the car’s interior acoustic characteristics, and

then creates an auto-equalizer curve based on

that information.

! To perform this function, dedicated micro-

phone (e.g. CD-MC20) is required.

WARNING

As a loud tone (noise) may be emitted from the

speakers when measuring the car’s interior

acoustic characteristics, never perform auto TA

or auto EQ while driving.

CAUTION

! Thoroughly check the conditions before per-

forming auto EQ as the speakers may be da-

maged if these functions are performed when:

— The speakers are incorrectly connected.

(For example, when a rear speaker is con-

nected as a subwoofer output.)

— A speaker is connected to a power amp de-

livering output higher than the speaker’s

maximum input power capability.

! If the microphone is placed in an unsuitable

position the measurement tone may become

loud and measurement may take a long time,

resulting in battery drainage. Be sure to place

the microphone in the specified location.

Before operating the auto EQ

function

! Carry out auto EQ in as quiet a place as

possible, with the car engine and air condi-

tioning switched off. Also cut power to car

phones or portable telephones in the car, or

remove them from the car before carrying

out auto EQ. Sounds other than the mea-

surement tone (surrounding sounds, en-

gine sound, telephones ringing etc.) may

prevent correct measurement of the car in-

terior acoustic characteristics.

! Be sure to carry out auto EQ using the op-

tional microphone. Using another micro-

phone may prevent measurement, or result

in incorrect measurement of the car inter-

ior acoustic characteristics.

! In order to perform auto EQ, the front

speaker must be connected.

! When this unit is connected to a power

amp with input level control, auto EQ may

not be possible if the power amp’s input

level is set below the standard level.

! When this unit is connected to a power

amp with an LPF, turn this LPF off before

performing auto EQ. Also set the cut-off fre-

quency for the built-in LPF of an active sub-

woofer to the highest frequency.

! The distance has been calculated by com-

puter to be the optimum delay to give accu-

rate results for the circumstances, so

please continue to use this value.

— The reflected sound within the car is

strong and delays occur.

— The LPF on active subwoofers or exter-

nal amps delay the lower sounds.

! Auto EQ changes the audio settings as fol-

lows:

— The fader/balance settings return to the

center position. (Refer to Using fader/

balance adjustment on page 54.)

— The equalizer curve switches to Flat.

(Refer to Recalling equalizer curves on

page 54.)

— The front, center and rear speakers will

automatically be adjusted to a high

pass filter setting.

! Previous settings for auto EQ will be over-

written.

Section

System settings

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer AVH-X3600DAB Seite 69

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer AVH-X3600DAB

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info