Bedienungsanleitung Pioneer AVH-Z9200DAB (Seite 3 von 64) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

699576

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

X:\print\Pioneer\19AJ\HIGH\19_High_EU_QRD3723(A5_Horizon)_INST\020Chapter_GB.fm

AVH-Z9200DAB

19_High_EU_QRD3723(A5_Horizon)

English

V DC). The control signal is output

through the blue/white lead, even if the

audio source is switched off.

Important

When this product is in [Power OFF] mode,

the control signal is also turned off. If

[Power OFF] mode is cancelled, the control

signal is output again and the aerial is

extended with the auto aerial function (if

the aerial is being used). Be careful so that

the extended aerial does not come into

contact with any obstacles.

GPS aerial 3.55 m

Microphone 3 m

Vehicle Bus conversion cable 13 cm

Refer to the instruction manual for the

Vehicle Bus adapter (sold separately).

Digital Radio aerial input

RGB cable (supplied with Navigation

system)

This product

Pioneer navigation system

Contact your dealer to inquire about

the connectable navigation unit.

Aerial jack

AV cable IN/OUT

Power supply

Fuse (10 A)

Wired remote input

Hard-wired remote control adapter can

be connected (sold separately).

WARNING

IMPROPER CONNECTION MAY RESULT IN

SERIOUS DAMAGE OR INJURY

INCLUDING ELECTRICAL SHOCK, AND

INTERFERENCE WITH THE OPERATION

OF THE VEHICLE'S ANTILOCK BRAKING

SYSTEM, AUTOMATIC TRANSMISSION

AND SPEEDOMETER INDICATION.

Rear panel (main

terminals)

Power cord

To power supply

Depending on the kind of vehicle, the

function of 2* and 4* may be different.

In this case, be sure to connect 1* to 4*

and 3* to 2*.

Yellow (2*)

Back-up (or accessory)

Yellow (1*)

Connect to the constant 12 V supply

terminal.

Red (4*)

Accessory (or back-up)

Red (3*)

Connect to terminal controlled by

ignition switch (12 V DC).

Connect leads of the same colour to

each other.

Orange/white

To lighting switch terminal.

Black (earth)

To vehicle (metal) body.

Blue/white (5*)

The pin position of the ISO connector

will differ depending on the type of

vehicle. Connect 5* and 6* when Pin 5 is

an aerial control type. In another type of

vehicle, never connect 5* and 6*.

Blue/white (6*)

Connect to auto-aerial relay control

terminal (max. 300 mA 12 V DC).

Blue/white

Connect to system control terminal of

the power amp (max. 300 mA 12 V DC).

Violet/white

Of the two lead wires connected to the

back lamp, connect the one in which

the voltage changes when the gear shift

is in the REVERSE (R) position. This

connection enables the unit to sense

whether the car is moving forwards or

backwards.

Pink

Car speed signal input

Light green

Used to detect the ON/OFF status of the

handbrake. This lead must be

connected to the power supply side of

the handbrake switch.

Connection method

Clamp the lead (1) then clamp firmly

with needle-nosed pliers (2).

Power supply side

Handbrake switch

Earth side

Speaker leads

White: Front left + or high range left +

White/black: Front left – or high range

left –

Grey: Front right + or high range right +

Grey/black: Front right – or high range

right –

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer AVH-Z9200DAB Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer AVH-Z9200DAB

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info