Bedienungsanleitung Pioneer avic f10bt (Seite 137 von 172) (Englisch)

163018

137

Zoom out

Zoom in

Vorherige Seite

1/172

Nächste Seite

You cannot position your vehicle

on the map without a significant

positioning error.

The navigation system may not be

mounted securely in your vehicle.

Check that the navigation system is securely

mounted and, if necessary, consult the dealer

that installed the system.

The navigation system is installed

with an extreme angle exceeding

the installation angle limitations.

Confirm the installation angle. (The naviga-

tion system must be installed within the al-

lowed installation angle. For details, refer to

“Installation Manual”.)

Indication of the position of your ve-

hicle is misaligned after a U-turn or

reversing.

Check whether or not the reverse gear signal

input lead (violet) is connected properly. (The

navigation system works properly without the

lead connected, but positioning accuracy will

be adversely affected.)

The map colour does not switch

automatically between daytime

and nighttime.

[Day/Night Display] is set to [Day]. Check [Day/Night Display] setting and make

sure [Automatic] is selected. (Page 29)

The orange/white lead is not con-

nected.

Check the connection.

The screen is too bright. An improper value has been set on

“Brightness”.

Check the settings. (Page 122)

The display is very dim. The vehicle’s light is turned ON, and

[Automatic] is selected on [Day/

Night Display].

Read about [Day/Night Display ] setting and,

if desired, select [Day]. (Page 29)

An improper value has been set on

“Brightness”.

Check the settings. (Page 122)

No sounds of AV source are pro-

duced.

The volume level will not rise.

The volume level is low. Adjust the volume level.

The attenuator or mute is on. Turn the attenuator or mute off.

A speaker lead is disconnected. Check the connection.

The volume of navigation gui-

dance and beeps cannot be ad-

justed.

Tr y to adjust them with VOL (+/–)

button.

Turn the volume up or down using [Volume]

on the “System Settings” menu. (Page 70)

The person on the other end of

the phone call cannot hear the

conversation due to an echo.

The voice from the person on the

other end of the phone call is output

from the speakers and then picked

up by the microphone again, creat-

ing an echo.

Use the following methods to reduce the

echo:

—Lower the volume on the receiver

—Have both parties pause slightly before

speaking

There’s no picture. The handbrake cord is not con-

nected.

Connect the handbrake cord, and apply the

handbrake.

The handbrake is not applied. Connect the handbrake cord, and apply the

handbrake.

The backlight of the LCD panel is

turned off.

Turn on the backlight. (Page 74)

“Rear display” picture disap-

pears.

The source disc being listened to in

the navigation system has been

ejected.

Before ejecting the disc, switch the source.

This problem may occur when certain con-

nection methods are used.

There is a problem with the “Rear

display”, for example a faulty wiring

connection.

Check the “Rear display” and its connect ion.

An AV source that cannot output to

the rear display is selected.

Select an appropriate AV source.

Appendix

Engb

137

Appendix

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer avic f10bt Seite 137

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer avic f10bt

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info