Bedienungsanleitung Pioneer AVIC-F9220BT (Seite 163 von 200) (Englisch)

454858

163

Zoom out

Zoom in

Vorherige Seite

1/200

Nächste Seite

Symptom Cause Action (Reference)

You cannot position your vehicle

on the map without a significant

positioning error.

Something covers the GPS aerial. Do not cover the GPS aerial with spray paint

or vehicle wax, because this may block the re-

ception of GPS signals. Snow buildup can

also degrade the signals.

Signals from the vehicle’s speed

pulse are not being picked up prop-

erly.

Check that the cables are properly connected.

If necessary, consult the dealer that installed

the system.

The navigation system may not be

mounted securely in your vehicle.

Check that the navigation system is securely

mounted and, if necessary, consult the dealer

that installed the system.

The navigation system is installed

with an extreme angle exceeding

the installation angle limitations.

Confirm the installation angle. (The naviga-

tion system must be installed within the al-

lowed installation angle. For details, refer to

Installation Manual.)

Indication of the position of your ve-

hicle is misaligned after a U-turn or

reversing.

Check whether or not the reverse gear signal

input lead (violet) is connected properly. (The

navigation system works properly without the

lead connected, but positioning accuracy will

be adversely affected.)

“Eco Graph ” is not available. The navigation system is unable to

obtain past average fuel mileage

data, so “Eco Graph” cannot be dis-

played.

Drive about 10 km on a road without obstruc-

tions. Then park your vehicle in a safe place,

turn off the navigation system and turn the

power to the navigation system back on.

The map colour does not switch

automatically between daytime

and nighttime.

“Day/Night Display” is set to

“Day”.

Check “Day/Night Display” setting and

make sure “Automatic” is selected. (Page

134)

The orange/white lead is not con-

nected.

Check the connection.

The screen is too bright. Picture quality adjustment of the

display is not correct.

Adjust the picture quality. (Page 143)

The display is very dim. The vehicle’s light is turned ON, and

“Automatic” is selected on “Day/

Night Display”.

Read about “Day/Night Display” setting

and, if desired, select “Day”. (Page 134)

Picture quality adjustment of the

display is not correct.

Adjust the picture quality. (Page 143)

No sounds of AV source are pro-

duced.

The volume level will not rise.

The volume level is low. Adjust the volume level.

The attenuator or mute is on. Turn the attenuator or mute off.

A speaker lead is disconnected. Check the connection.

The volume of navigation gui-

dance and beeps cannot be ad-

justed.

VOL (+/– ) button is used to adjust

the volume.

Turn the volume up or down using [Volume]

on the “System Settings” menu. (Page 138)

The person on the other end of

the phone call cannot hear the

conversation due to an echo.

The voice from the person on the

other end of the phone call is output

from the speakers and then picked

up by the microphone again, creat-

ing an echo.

Use the following methods to reduce the

echo:

—Lower the volume on the receiver

—Have both parties pause slightly before

speaking

Engb

163

Appendix

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer AVIC-F9220BT Seite 163

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer AVIC-F9220BT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info