Bedienungsanleitung Pioneer avic x 1 (Seite 112 von 125) (Englisch)

162564

112

Zoom out

Zoom in

Vorherige Seite

1/125

Nächste Seite

110

Appendix NAVI/AV

Error Messages

When problems occur with disc playback, an error message appears on the display. Refer to the table

below to identify the problem, then take the suggested corrective action. If the error persists, contact

your dealer or your nearest PIONEER Service Centre.

Speed pulse wire is not connected.

Please be sure to connect the system

to the speed pulse wire. Accuracy is

not fully ensured without speed

pulse.

The speed signal input (pink lead

wire) of the power cable is not con-

nected.

To operate with 3D hybrid mode, con-

nect the speed signal input (pink

lead wire) of the power cable cor-

rectly. Although it can be operated

with Simple hybrid mode without

connecting the speed signal input,

the precision of the positioning will

be less accurate.

Vibration is detected. Please turn the

system power off and check the

installation. After checking, please

re-boot the system and press “OK”.

While the vehicle is stationary, the

Navigation System is installed in a

place where the navigation unit may

be affected by a large vibration.

Re-install the navigation unit of the

Navigation System in a place where

the navigation unit will not be

affected by vibration.

Direction of G sensor is not correct.

Please turn the system power off and

check the installation. After check-

ing, please re-boot the system and

press “OK”.

Direction of G sensor is set incor-

rectly.

See the “Installation Manual” and set

the direction of the Hide-away unit

correctly.

Gyro Sensor is not working properly.

Please consult your dealer or Pioneer

service centre.

Abnormal output of Gyrosensor is

detected.

Note down the error code shown on

the screen; turn off the power, and

then contact your nearest Pioneer

service facility.

Your route could not be found. If the distance to the destination is

too far and cannot be set.

Change the destination to a location

that is closer and divide up the route.

Your journey can not avoid the speci-

fied area.

If route setting cannot avoid speci-

fied Areas to Avoid.

Choose whether or not to try setting

a route through the area.

Memory is full. If there are already 300 items when

you attempt to register an item in the

Address Book.

Delete some destinations as appro-

priate.

Irregular character strings. Please

input again.

A symbol that cannot be pronounced

was entered.

Enter a word that can be pro-

nounced.

An error has occurred. Please note

the following error code and switch

power off.

In the case of a system failure. Note down the error code shown on

the screen; turn off the power, and

then contact your nearest Pioneer

service facility.

DVD Player is overheating. Discon-

tinue until temperature drops.

The built-in DVD drive has over-

heated.

Cut the power off, and wait for a

while before turning the power on

again.

Message When What to do

Message Cause Action (See)

ERROR-02 Dirty Clean disc.

Scratched disc Replace disc.

ERROR-05 Electrical or mechanical Press RESET button. (“Hardware manual”

and refer to page 105 in this manual.)

DIFFERENT REGION

DISC (REGION ERR)

The disc does not have the same region

number as this unit

Replace the DVD video with one bearing the

correct region number.

NON PLAYABLE DISC

(NON-PLAY)

This type of disc cannot be played by this

unit

Replace the disc with one this unit can play.

The disc is loaded upside down Check that the disc is loaded correctly.

THERMAL PROTEC-

TION IN MOTION

(TEMP)

The temperature of this unit is outside of

the normal operating range

Wait until the unit’s temperature returns to

within normal operating limits.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer avic x 1 Seite 112

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer avic x 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info