Bedienungsanleitung Pioneer avic-x1bt (Seite 19 von 26) (Englisch)

162189

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Appendix

Troubleshooting

➲ Troubleshooting problems other than those described below ➞ Appendix of the Operation Manual

Symptom Cause Action (See)

No picture. The handbrake cord is not connected. Connect the handbrake cord, and apply the

handbrake.

The handbrake is not applied. Connect the handbrake cord, and apply the

handbrake.

The picture is

stretched, the aspect is

incorrect.

The aspect setting is incorrect for the dis-

play.

Select the appropriate setting for your dis-

play. (➞ “Changing the Wide Screen Mode”

and “Operating the Picture Adjustment” in

the Operation Mannual.)

Rear display picture

disappears.

The source disc being played back with the

navigation system has been ejected.

Before ejecting the disc, switch the source.

This problem may occur when certain con-

nection methods are used.

The REAR/GUIDE button was pressed and

REAR ON mode switched off.

Press the REAR/GUIDE button to turn

REAR ON mode on.

There was a problem with the rear display

or a faulty wiring connection, for example.

Check the rear display and its connection.

Rear View is selected on the screen. Select view mode other than Rear View.

When the gear stick is in [R], the screen dis-

plays rear view camera images. (When

“NAVI” is selected in REAR DISP menu.)

Move the gear stick to a position other than

[R]. (Select “SOURCE” in REAR DISP

menu.)

A source without video is selected. Switch to a source with a video.

Operating PICTURE ADJUSTMENT. There is no picture on the rear display while

PICTURE ADJUSTMENT is carried out.

Nothing is displayed

and the touch panel

keys cannot be used.

The setting for the rear view camera is

incorrect.

The gear stick was placed in [R] when the

rear view camera was not connected.

Connect a rear view camera correctly.

Press the NAVI/AV button to return to the

source display and then select the correct

setting for CAMERA.

➲ About CAMERA setting

➞ Operation

Manual

Volume of beeps and

navigation guidance

cannot be adjusted.

You cannot adjust these parameters with

the VOLUME/ATT button.

• Turn the volume up or down with

“Volume” in the Setting menu.

•Press the REAR/GUIDE button ond turn

the volume up or down.

Playback is not possi-

ble.

The disc is dirty. Clean disc.

The loaded disc is a type your navigation

system cannot play.

Check what type the disc is. (➞ Page 18)

Non compatible video system disc is

loaded.

Change to a disc compatible to your video

system. (➞ Page 18)

The loaded disc has a different region

number from the navigation system.

Replace the disc with one featuring the

same region number as the navigation sys-

tem. (➞ Page 6)

LCD Panel knocks

against your vehicle’s

console or dashboard.

Incorrect angle setting. Press the ANGLE (+/–) button to adjust the

LCD angle. Forcibly adjusting the LCD panel

by hand may damage it.

Video image appears

grainy.

This happens when videos are viewed in

CINEMA or ZOOM mode.

Select a different mode to view videos.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer avic-x1bt Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer avic-x1bt

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info