Bedienungsanleitung Pioneer AVIC-X3 (Seite 135 von 164) (Englisch)

62771

135

Zoom out

Zoom in

Vorherige Seite

1/164

Nächste Seite

133

AppendixNAVI/AV

Troubleshooting

If you have problems operating your navigation system, refer to this section. The most common prob-

lems are listed below, along with likely causes and solutions. While this list is not comprehensive, it

should answer your most common problems. If a solution to your problem cannot be found here, con-

tact your dealer or the nearest authorised Pioneer service facility.

Problems in the navigation screen

Symptom Cause Action (See)

Power doesn’t turn on.

The unit doesn’t operate.

Leads and connectors are incorrectly

connected.

Confirm once more that all connec-

tions are correct.

The fuse is blown. Rectify the reason for the fuse blow-

ing, then replace the fuse. Be very

sure to install a correct fuse with the

same rate.

Noise and other factors are causing

the built-in microprocessor to oper-

ate incorrectly.

Press the RESET button. (➞ Refer to

page 131 in this manual.)

The power turns on, but the unit does

not operate.

The 30-pin cable has been discon-

nected and then reconnected.

Press the RESET button while the

power is on.

When the ignition switch is turned

ON (or turned to ACC), the motor

sounds.

The navigation system confirms

whether a disc is loaded or not.

This is a normal operation.

You cannot position your vehicle on

the map or the positioning error is

large.

The quality of signals from the GPS

satellites is poor, causing reduced

positioning accuracy. Such a loss of

signal quality may happen for the fol-

lowing reasons:

• The GPS aerial is in an unsuitable

location.

• Obstacles are blocking signals

from the satellites.

• The position of satellites relative to

your vehicle is bad.

• Signals from the GPS satellites

have been modified to reduce

accuracy. (GPS satellites are oper-

ated by the US Department of

Defense, and the US government

reserves the right to distort posi-

tioning data for military reasons.

This may lead to greater position-

ing errors.)

• If a vehicle phone or mobile phone

is used near the GPS aerial, GPS

reception may be lost temporarily.

Check the GPS signal reception (➞

Page 61) and the position of the GPS

aerial if necessary, or continue driv-

ing until reception improves. Keep

the aerial clear.

Something covers the GPS aerial. Do not cover the GPS aerial with

spray paint or vehicle wax, because

this may block the reception of GPS

signals. Snow buildup can also

degrade the signals.

Signals from the vehicle’s speed

pulse are not being picked up prop-

erly.

Check that the cables are properly

connected. If necessary, consult the

dealer that installed the system.

The navigation system may not be

mounted securely in your vehicle.

Check that the navigation system is

securely mounted and, if necessary,

consult the dealer that installed the

system.

MAN-AVIC-X3-EN.book Page 133 Wednesday, June 6, 2007 10:15 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer AVIC-X3 Seite 135

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer AVIC-X3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info